The paper presents our latest experimental results on the influence of temperature, an external electric field, and hydrostatic pressure on propagation properties of the photonic crystal fibers infiltrated with liquid crystals of low and medium material anisotropies. Measurand-induced shifts of the photonic bandgap wavelengths give information about the value of temperature, voltage, and pressure. Moreover, temperature-dependent positions of the photonic bandgap wavelengths in the transmission spectrum can serve to determine the thermal characteristics of the liquid crystal ordinary refractive index.
Photonic liquid crystal fibers (PLCFs) can be categorized in two principal groups: index guiding PLCFs and photonic bandgap PLCFs. In this paper we focus on index guiding PLCFs in which effective refractive index of the micro structured cladding filled with liquid crystal is lower than refractive index of the fiber core. In these fibers broadband propagation of light is observed and also effective tuning of guiding properties is possible. In this paper PLCFs with tunable attenuation, retardation and polarization dependent losses are reported. We also enumerate some potential applications of index-guiding PLCFs, together with discussion of few technical issues important in the context of future development (i.e., effective electrical steering and connecting with standard fibers).
13 January 2012 in IEEE Photonics Technology Letters
In this letter, we report a new very large mode area multimode photonic band-gap (PBG) propagation in a solid core photonic crystal fiber (PCF) filled with a liquid crystal (LC). The host fiber was designed with a 50- μm core diameter to optimize the light coupling from standard multimode fibers. After filling it with LCs, multimode selective propagation was observed and it was possible to tune the bands with temperature. The mode field was well localized in the core area and compared to our previous works, a much smaller percentage of optical power penetrates the LC-filled holes. Consequently, the scattering loss is reduced, allowing for lower insertion losses. Attenuation was measured by the cut-back technique and for one of the band gaps it was 0.16 dB/cm, which, to the best of our knowledge, has been the lowest level of attenuation reported so far in PBG-guiding LC-filled PCFs.
The paper describes four different types of micro-electrodes systems for dynamic electric field sensing with photonic crystal fibers infiltrated with liquid crystals. The shortest switching time ~20 ms was achieved by using a flexible-flat-cable electrode system. A capillary system with four micro-electrodes (τ ~ 36 ms) appeared to be the most convenient to operate with photonic liquid crystal fibers. The capillary system was also theoretically analyzed and presented in this paper.