This paper reports a linear multiply-accumulate (MAC) operation conducted on a crossbar memory array based on 28nm high-k metal gate (HKMG) Complementary Metal Oxide Semiconductor (CMOS) and ferroelectric field effect transistor (FeFET). The fabrication is conducted at GlobalFoundries with their standard 28nm technology. The crossbar arrays show a 100% yield in MAC operation on a 300mm wafer. The arrays were divided into 8×8 segments. The FeFET crossbar arrays were fabricated with access transistors, current-limiter transistors and a current-mode analog-to-digital converter (ADC) on the same wafer. Finally, the data retention characteristics reveal excellent data retention characteristics up to 5×10 4 seconds, which makes this memory array suitable for carrying out MAC operations in inference engine applications.
4 November 2022 in IEEE Transactions on Electron Devices
This article reports a novel ferroelectric field-effect transistor (FeFET)-based crossbar array cascaded with an external resistor. The external resistor is shunted with the column of the FeFET array, as a current limiter and reduces the impact of variations in drain current ( $\textit{I}_{\textit{d}}$ ), especially in a low threshold voltage (LVT) state. We have designed crossbar arrays of 8 $\times$ 8 sizes and performed multiply-and-accumulate (MAC) operations. Furthermore, we have evaluated the performance of the current limited FeFET crossbar array in system-level applications. Finally, the system-level performance evaluation was done by neuromorphic simulation of the resistor-shunted FeFET crossbar array. The crossbar array achieved software-comparable inference accuracy ( $\sim$ 97%) for National Institute of Standards and Technology (MNIST) datasets with multilayer perceptron (MLP) neural network, whereas the crossbar arrays built solely with FeFETs failed to learn, yielding only 9.8% accuracy.
The discovery of ferroelectricity in hafnium oxide has propelled ferroelectric devices to the forefront of nanoelectronics, offering distinct advantages over alternative technologies. Ferroelectric memories, such as Ferroelectric Random Access Memories (FeRAM) and the Ferroelectric Field Effect Transistor (FeFET), combine non‐volatility with high‐speed operation and low power consumption, though they contend with specific challenges, including variability and endurance limitations. Meanwhile, piezoelectric and pyroelectric sensors/actuators exploit the capability of ferroelectric materials to interconvert mechanical or thermal energy with electrical signals. These sensors demonstrate exceptional sensitivity, though factors such as material fatigue and temperature stability can impact their performance. Additionally, radio frequency devices, particularly varactors, utilize ferroelectric materials to enable tunable capacitance, enhancing dynamic control. This review assesses the advantages and current challenges across these technologies, offering insights into prospective solutions.
14 July 2023 in IEEE Transactions on Nanotechnology
This article proposes a memory cell, denoted by 1F-1T, consisting of a ferroelectric field-effect transistor (FeFET) cascaded with another current-limiting transistor (T). The transistor reduces the impact of drain current ( $I_{d}$ ) variations by limiting the on-state current in FeFET. The experimental data from our 28nm high-k-metal-gate (HKMG) based FeFET calibrates and simulates the memory arrays. The simulation indicates a significant improvement in bit-line (BL) current ( $I_{BL}$ ) variation and the accuracy of vector-matrix multiplication of the 1F-1T memory array. The system-level in-memory computing simulation with 1F-1T synapses shows an inference accuracy of 97.6% for the MNIST hand-written digits with multi-layer perceptron (MLP) neural networks.
Harnessing multibit precision in nonvolatile memory (NVM)‐based synaptic core can accelerate multiply and accumulate (MAC) operation of deep neural network (DNN). However, NVM‐based synaptic cores suffer from the trade‐off between bit density and performance. The undesired performance degradation with scaling, limited bit precision, and asymmetry associated with weight update poses a severe bottleneck in realizing a high‐density synaptic core. Herein, 1) evaluation of novel differential mode ferroelectric field‐effect transistor (DM‐FeFET) bitcell on a crossbar array of 4 K devices; 2) validation of weighted sum operation on 28 nm DM‐FeFET crossbar array; 3) bit density of 223Mb mm−2, which is ≈2× improvement compared to conventional FeFET array; 4) 196 TOPS/W energy efficiency for VGG‐8 network; and 5) superior bit error rate (BER) resilience showing ≈94% training and 88% inference accuracy with 1% BER are demonstrated.
This article reports an improvement in the low- frequency noise characteristics in hafnium oxide-based (HfO 2 ) ferroelectric field-effect transistors (FeFET) by interfacial layer (IL) engineering. FeFET devices with silicon dioxide (SiO 2 ) and silicon oxynitride (SiON) as IL were fabricated and characterised. FeFETs with SiON interfaces demonstrated an excellent improvement in variation, and low-frequency noise characteristics. The wider memory window for operation in FeFETs with SiON IL also allows for a higher noise tolerance during the inference operation. Finally, the evaluation of system performance by neuromorphic simulation shows that FeFET with SiON IL are highly immune to noise degradation and endurance, without retention penalty.