Sukhrob Abdulazhanov

Mr. Sukhrob Abdulazhanov

Fraunhofer Institute for Photonic Microsystems
+1
orcid

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
25 October 2022 in IEEE Electron Device Letters
Verified
Journal Article
Open access
SDSourav De
Sourav De
FMFranz Muller
Franz Muller
NLNellie Laleni
Nellie Laleni
MLMaximilian Lederer
Maximilian Lederer
YRYannick Raffel
Yannick Raffel
Thomas KämpfeThomas Kämpfe
Thomas Kämpfe
This paper reports a linear multiply-accumulate (MAC) operation conducted on a crossbar memory array based on 28nm high-k metal gate (HKMG) Complementary Metal Oxide Semiconductor (CMOS) and ferroelectric field effect transistor (FeFET). The fabrication is conducted at GlobalFoundries with their standard 28nm technology. The crossbar arrays show a 100% yield in MAC operation on a 300mm wafer. The arrays were divided into 8×8 segments. The FeFET crossbar arrays were fabricated with access transistors, current-limiter transistors and a current-mode analog-to-digital converter (ADC) on the same wafer. Finally, the data retention characteristics reveal excellent data retention characteristics up to 5×10 4 seconds, which makes this memory array suitable for carrying out MAC operations in inference engine applications.

4 November 2022 in IEEE Transactions on Electron Devices
Verified
Journal Article
Open access
SDSourav De
Sourav De
FMFranz Muller
Franz Muller
STSunanda Thunder
Sunanda Thunder
SASukhrob Abdulazhanov
Sukhrob Abdulazhanov
NLNellie Laleni
Nellie Laleni
Thomas KämpfeThomas Kämpfe
Thomas Kämpfe
This article reports a novel ferroelectric field-effect transistor (FeFET)-based crossbar array cascaded with an external resistor. The external resistor is shunted with the column of the FeFET array, as a current limiter and reduces the impact of variations in drain current ( $\textit{I}_{\textit{d}}$ ), especially in a low threshold voltage (LVT) state. We have designed crossbar arrays of 8 $\times$ 8 sizes and performed multiply-and-accumulate (MAC) operations. Furthermore, we have evaluated the performance of the current limited FeFET crossbar array in system-level applications. Finally, the system-level performance evaluation was done by neuromorphic simulation of the resistor-shunted FeFET crossbar array. The crossbar array achieved software-comparable inference accuracy ( $\sim$ 97%) for National Institute of Standards and Technology (MNIST) datasets with multilayer perceptron (MLP) neural network, whereas the crossbar arrays built solely with FeFETs failed to learn, yielding only 9.8% accuracy.

26 February 2025 in Advanced Electronic Materials
Verified
Journal Article
Open access
DLDavid Lehninger
David Lehninger
FMFranz Müller
Franz Müller
YRYannick Raffel
Yannick Raffel
SYShouzhuo Yang
Shouzhuo Yang
MNMarkus Neuber
Markus Neuber
MLMaximilian Lederer
Maximilian Lederer
The discovery of ferroelectricity in hafnium oxide has propelled ferroelectric devices to the forefront of nanoelectronics, offering distinct advantages over alternative technologies. Ferroelectric memories, such as Ferroelectric Random Access Memories (FeRAM) and the Ferroelectric Field Effect Transistor (FeFET), combine non‐volatility with high‐speed operation and low power consumption, though they contend with specific challenges, including variability and endurance limitations. Meanwhile, piezoelectric and pyroelectric sensors/actuators exploit the capability of ferroelectric materials to interconvert mechanical or thermal energy with electrical signals. These sensors demonstrate exceptional sensitivity, though factors such as material fatigue and temperature stability can impact their performance. Additionally, radio frequency devices, particularly varactors, utilize ferroelectric materials to enable tunable capacitance, enhancing dynamic control. This review assesses the advantages and current challenges across these technologies, offering insights into prospective solutions.

27 August 2021 in IEEE Transactions on Electron Devices
Verified
Journal Article
Closed access
SASukhrob Abdulazhanov
Sukhrob Abdulazhanov
MLMaximilian Lederer
Maximilian Lederer
DLDavid Lehninger
David Lehninger
CMClemens Mart
Clemens Mart
TATarek Ali
Tarek Ali
GGGerald Gerlach
Gerald Gerlach
In this article, we present the capacitance-voltage (C-V) characteristics of HfₓZr₁₋ₓO₂metal-ferroelectric-metal (MFM) thin-film capacitors with various Zr doping, thicknesses, and annealing temperatures. The influence of doping, electric field cycling, and annealing temperature on tuning characteristics (tunability) was analyzed and an optimized bias region for the maximum tunability was defined. Additional focus was made on an antiferroelectric-like (AFE) behavior, which occurs for > 50% Zr doping. The presence of both the ferroelectric and the AFE phase manifests itself in specific C-V behavior, where a reduced bias range is required for tuning, however, at the cost of a smaller tunability. The suitability of this behavior for varactor applications is also discussed.

23 December 2022 in ACS Applied Electronic Materials
Verified
Journal Article
Open access
SASukhrob Abdulazhanov
Sukhrob Abdulazhanov
QLQuang Huy Le
Quang Huy Le
DHDang Khoa Huynh
Dang Khoa Huynh
DWDefu Wang
Defu Wang
DLDavid Lehninger
David Lehninger
GGGerald Gerlach
Gerald Gerlach
In this paper, we present a broadband microwave characterization of ferroelectric hafnium zirconium oxide (Hf0.5Zr0.5O2) metal-ferroelectric-metal (MFM) thin film varactor from 1 kHz up to 0.11 THz. The varactor is integrated into the back-end-of-line (BEoL) of 180 nm CMOS technology as a shunting capacitor for the coplanar waveguide (CPW) transmission line. At low frequencies, the varactor shows a slight imprint behavior, with a maximum tunability of 15% after the wake-up. In the radio-and mmWave frequency range, the varactor's maximum tunability decreases slightly from 13% at 30 MHz to 10% at 110 GHz. Ferroelectric varactors were known for their frequency-independent, linear tunability as well as low loss. However, this potential was never fully realized due to limitations in integration. Here, we show that ferroelectric HfO2 thin films with good back-end-of-line compatibility support very large scale integration. This opens up a broad range of possible applications in the mmWave and THz frequency range such as 6G communications, imaging radar, or THz imaging.

12 December 2020
Verified
Conference Paper
Closed access
CMClemens Mart
Clemens Mart
SASukhrob Abdulazhanov
Sukhrob Abdulazhanov
MCM. Czernohorsky
M. Czernohorsky
Thomas KämpfeThomas Kämpfe
Thomas Kämpfe
DLD. Lehninger
D. Lehninger
LELukas Eng
Lukas Eng
We demonstrate the feasibility of thermal energy recovery in the back end of line (BEoL) employing CMOS-compatible ferroelectric hafnium oxide. Efficient pyroelectric energy harvesting with a sizable power density of 92 mWcm -3 under typical thermal conditions is achieved. Our energy harvesting approach exceeds the efficiency limit of commonly-used thermoelectric materials, without using a heat switch. The low-voltage operation, scalability, and abundance in CMOS manufacturing make HfO 2 -based ferroelectrics promising candidates for integrated energy harvesting and solid-state refrigeration applications.