Slice energy spread is one of the key parameters in free electron laser optimizations, but its accurate measurement is not straightforward. Two recent studies from high energy (>= 100 MeV) photoinjectors at SwissFEL and European x-ray free electron laser (XFEL) have reported much higher slice energy spread than expected at their XFEL working points (200-250 pC). In this paper, a new method for measuring slice energy spread at lower beam energy (similar to 20 MeV) is proposed and demonstrated at the PhotoInjector Test facility at DESY Zeuthen, and the results for 250 pC are much lower than those measured at high energy injectors.
1 September 2021 in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
Photoinjectors are the main high brightness electron sources for x-ray free electron lasers (XFELs). Photoinjector emittance reduction is one of the key knobs for improving XFEL lasing, so precise emittance measurement is critical. It is well known that rms emittance is very sensitive to low intensity tails of particle distributions in the phase space, whose measurement depends on the signal to noise ratio and image processing procedures. Such sensitivities make the interpretations of beam transverse brightness challenging, leading to different emittance definitions to reduce the impact of tail particles. In this paper, transverse phase space is analyzed in action and phase coordinates for both analytical models and experiments, which gives a more intuitive way to calculate the beam core brightness.
There is a high demand for intense THz sources since “many excitation mechanisms of matter resonate in the terahertz regime” especially for condensed matters. “Accelerator-based THz sources provide the wide tunability together with high intensity and repetition rates beyond 100 kHz, that will enable broad application at the European XFEL to the most interesting scientific problems in the field” [1]. Supported by European XFEL a proof of principle study is started at the Photo-Injector Test Facility located at DESY in Zeuthen site (PITZ). Since PITZ and European XFEL electron sources are identical the X-ray and THz radiation can be produced with identical bunch train structure so that for every X-ray pulse a corresponding THz pulse can be provided for the pump-and- probe experiments.
The Photo Injector Test facility at DESY in Zeuthen (PITZ) is developing a THz SASE FEL as a prototype high repetition rate accelerator-based source for the THz-pumped, X-ray-probed experiments at the European XFEL. For the generation of THz pulses of mJ-level energy from SASE, an electron beam with a high charge (up to 4 nC) and high peak current (~200 A) will be injected into an LCLS-I undulator, which is currently being installed at the end of the photo-injector. The narrow vacuum chamber (11x5 mm) between the magnetic poles and the strong vertical focusing from the undulator, as well as the lack of beam diagnostics, have made it a challenge to match the space-charge dominated beam into the undulator without beam loss during the following transport. In this paper, boundary conditions of a matched electron beam will be discussed and the simulation and experimental study on our matching strategy will be presented.
A magnetic bunch compressor has been recently designed for an accelerator-based THz source which is under development at the Photo Injector Test facility at DESY in Zeuthen (PITZ). The THz source is assumed to be a prototype for an accelerator-based THz source for pump-probe experiments at the European XFEL. As an electron bunch is compressed to achieve higher bunch currents for the THz source, we investigate the beam dynamics in the bunch compressor by numerical simulations. A start-to-end simulation optimizer has been developed by combining the use of ASTRA, IMPACT-T, and OCELOT to support the design of the THz source prototype. Coherent synchrotron radiation effects degrade the compression performance for our study cases with bunch charges up to 4 nC and beam energy of 17 MeV at a bending angle of 19 degrees. Simulation and preliminary beam characteristic results will be presented in this paper.