Hai Jun Cho

Hai Jun Cho

Auto-generated profile, based on publicly available information

Hai Jun Cho

Research Institute for Electronic Science, Hokkaido University, N20W10, Kita, Sapporo 001-0020, Japan

Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 December 2018 in Composites Part B: Engineering
Verified
Journal Article
Closed access
HCHai Jun Cho
Hai Jun Cho
YKYoung-June Kim
Young-June Kim
UEUwe Erb
Uwe Erb

1 June 2019 in Journal of Alloys and Compounds
Verified
Journal Article
Closed access
HCHai Jun Cho
Hai Jun Cho
DYDong Yan
Dong Yan
JTJason Tam
Jason Tam
UEUwe Erb
Uwe Erb

1 September 2019 in Materialia
Verified
Journal Article
Closed access
BYB. Yu
B. Yu
JTJ. Tam
J. Tam
WLW. Li
W. Li
HCH.J. Cho
H.J. Cho
JLJ.-G. Legoux
J.-G. Legoux
UEU. Erb
U. Erb

12 December 2018 in APL Materials
Verified
Journal Article
Open access
HCHai Jun Cho
Hai Jun Cho
TOTakaki Onozato
Takaki Onozato
MWMian Wei
Mian Wei
ASAnup Sanchela
Anup Sanchela
HOHiromichi Ohta
Hiromichi Ohta
Wide bandgap (Eg ∼ 3.1 eV) La-doped BaSnO3 (LBSO) has attracted increasing attention as one of the transparent oxide semiconductors since its bulk single crystal shows a high carrier mobility (∼320 cm2 V−1 s−1) with a high carrier concentration (∼1020 cm−3). For this reason, many researchers have fabricated LBSO epitaxial films thus far, but the obtainable carrier mobility is substantially low compared to that of single crystals due to the formation of the lattice/structural defects. Here we report that the mobility suppression in LBSO films can be lifted by a simple vacuum annealing process. The oxygen vacancies generated from vacuum annealing reduced the thermal stability of LBSO films on MgO substrates, which increased their carrier concentrations and lateral grain sizes at elevated temperatures. As a result, the carrier mobilities were greatly improved, which does not occur after heat treatment in air. We report a factorial design experiment for the vacuum annealing of LBSO films on MgO substrates and discuss the implications of the results. Our findings expand our current knowledge on the point defect formation in epitaxial LBSO films and show that vacuum annealing is a powerful tool for enhancing the mobility values of LBSO films.

13 January 2020 in Applied Physics Letters
Verified
Journal Article
Open access
PDF file
MWMian Wei
Mian Wei
ASAnup Sanchela
Anup Sanchela
BFBin Feng
Bin Feng
YIYuichi Ikuhara
Yuichi Ikuhara
HCHai Jun Cho
Hai Jun Cho
HOHiromichi Ohta
Hiromichi Ohta
La-doped SrSnO3 (LSSO) is known as one of the deep-ultraviolet (DUV)-transparent conducting oxides with an energy bandgap of ∼4.6 eV. Since LSSO can be grown heteroepitaxially on more wide bandgap substrates such as MgO (Eg ∼ 7.8 eV), LSSO is considered to be a good candidate for a DUV-transparent electrode. However, the electrical conductivity of LSSO films is below 1000 S cm−1, most likely due to the low solubility of the La ion in the LSSO lattice. Here, we report that high electrically conducting (>3000 S cm−1) LSSO thin films with an energy bandgap of ∼4.6 eV can be fabricated by pulsed laser deposition on a MgO substrate followed by a simple annealing in vacuum. From the X-ray diffraction and the scanning transmission electron microscopy analyses, we found that lateral grain growth occurred during the annealing, which improved the activation rate of the La ion, leading to a significant improvement of the carrier concentration (3.26 × 1020 cm−3) and Hall mobility (55.8 cm2 V−1 s−1). The present DUV-transparent oxide semiconductor would be useful as a transparent electrode for developing optoelectronic devices, which transmit and/or emit DUV-light.

21 February 2023 in Advanced Functional Materials
Verified
Journal Article
Open access
QYQian Yang
Qian Yang
HCHai Jun Cho
Hai Jun Cho
ZBZhiping Bian
Zhiping Bian
MYMitsuki Yoshimura
Mitsuki Yoshimura
JLJoonhyuk Lee
Joonhyuk Lee
HOHiromichi Ohta
Hiromichi Ohta
Thermal transistors that electrically control heat flow have attracted growing attention as thermal management devices and phonon logic circuits. Although several thermal transistors are demonstrated, the use of liquid electrolytes may limit the application from the viewpoint of reliability or liquid leakage. Herein, a solid‐state thermal transistor that can electrochemically control the heat flow with an on‐to‐off ratio of the thermal conductivity (κ) of ≈4 without using any liquid is demonstrated. The thermal transistor is a multilayer film composed of an upper electrode, strontium cobaltite (SrCoOx), solid electrolyte, and bottom electrode. An electrochemical redox treatment at 280 °C in air repeatedly modulates the crystal structure and κ of the SrCoOx layer. The fully oxidized perovskite‐structured SrCoO3 layer shows a high κ ≈3 .8 W m−1 K−1, whereas the fully reduced defect perovskite‐structured SrCoO2 layer shows a low κ ≈ 0.95 W m−1 K−1. The present solid‐state electrochemical thermal transistor may become next‐generation devices toward future thermal management technology.