In this work, polyaniline (PANI) is synthesized via oxidative polymerization of aniline and purified using organic solvents where the emeraldine phase is isolated by employing a phase separation system. The above contributes to the increase in the percentage yield compared to previous works and the possibility of being used as a single phase. In addition, the PANI/AgNPs composite is prepared in situ at the polymerization of aniline, adding silver nitrate and glycine to create the AgNPs inside the PANI matrix by controlling the pH, temperature, time of reaction and incorporating a new purification technique.
19 December 2022 in Journal of the Mechanical Behavior of Biomedical Materials
In this work, we synthesized five novel iron-based trimetallic layered double hydroxides (LDHs) by the urea-assisted co-precipitation method for the electrocatalytic water oxidation reaction (WOR). In particular, the synthesized electrocatalysts were labeled CoCuFe-LDH, ZnNiFe-LDH, ZnCoFe-LDH, ZnCuFe-LDH, and CoGaFe-LDH. The electrocatalysts were thoroughly characterized by means of Ultraviolet-visible spectroscopy (UV-Vis), N2 adsorption/desorption, and X-ray photoelectron spectroscopy (XPS). We analyzed the changes in the electronic structures, changes in the surface area, and the oxygen vacancies, respectively. X-ray diffraction (XRD) and transmission electron microscopy (TEM) showed that the materials had the hydrotalcite-like structure typical of LDHs. Electrochemical results indicated that the best electrocatalyst was the CoGaFe-LDH achieving an overpotential of 369.9 mV at 10 mA cm−2 and a Tafel slope of 64.8 mV dec−1 in alkaline conditions (KOH 1 M). Additionally, this material displayed a charge transfer resistance (Rct) of 30.1 Ω cm2. Electrochemical measurements indicated that the materials containing Zn2+ exhibit low kinetics; whilst materials with Co2+ or Ga3+ yield the best performances. The catalytic activity of the CoGaFe-LDH can be attributed to the decrease of the Rct caused by electronic effects due to the addition of the Ga3+, lowering the thermodynamic barriers and thus enhancing the electron transfer. This work opens the door for a new approach to design efficient multimetallic catalysts based on the transition metals for WOR.
Silicone rubber (SR) is a material used for medical procedures, with a common example of its application being in implants for cosmetic or plastic surgeries. It is also an essential component for the development of medical devices. SR was functionalized with the polymeric prodrug of poly(2-methacryloyloxy-benzoic acid) (poly(2MBA)) to render the analgesic anti-inflammatory drug salicylic acid by hydrolysis. The system was designed by functionalizing SR films (0.5 cm × 1 cm) with a direct grafting method, using gamma irradiation (60Co source) to induce the polymerization process. The absorbed dose (from 20 to 100 kGy) and the monomer concentration (between 0.4 and 1.5 M) were critical in controlling the surface and the bulk modifications of SR. Grafting poly(2MBA) onto SR (SR-g-2MBA) were characterized by attenuated total reflectance Fourier transform infrared spectroscopy, thermogravimetric analysis, scanning electron microscopy/energy-dispersive X-ray spectrometry, fluorescence microscopy, the contact angle, and the swelling. SR-g-2MBA demonstrated the drug’s sustained and pH-dependent release in simulated physiological mediums (pH = 5.5 and 7.4). The drug’s release was quantified by high-performance liquid chromatography and confirmed by gas chromatography–mass spectrometry. Finally, cytocompatibility was demonstrated in murine fibroblast and human cervical cancer cell lines. The developed systems provide new polymeric drug release systems for medical silicone applications.