17 July 2020 in IEEE Journal of Solid-State Circuits
We present a new analog-to-digital converter (ADC)-based architecture of a phase-tracking receiver (PT-RX) optimized for ultra-low-power (ULP) and ultra-low-voltage (ULV) operations for the Internet of Things (IoT). The RX employs a type-II loop configuration that offers improved stability compared with the previous type-I PT-RX solutions. In addition, the type-II loop is also very tolerant of long run-lengths of consecutive ``1'' or ``0'' symbol sequences. Fabricated in 28-nm CMOS, the prototype PT-RX targets Bluetooth low energy (BLE) standard consuming only 1.5 mW at a supply of ≤0.7 V. It maintains an adjacent-channel rejection (ACR) of ≥-11/3.5/17/27 dB at 0/±1/±2/±3 MHz offset and can tolerate out-of-band (OOB) blockers of minimum -21 dBm across 1.0-3.5 GHz while also offering a best-in-class figure of merit (FoM) of 181 dB, with a 1-Mb/s BLE sensitivity of -93 dBm.
26 August 2022 in IEEE Transactions on Circuits and Systems I: Regular Papers
This paper presents a simple yet effective $G_m$ -boosting technique for improving gain and noise performance of millimeter-wave (mm-wave) low-noise amplifiers (LNAs) comprising triple-well transistors typically found in the modern bulk CMOS processes. The proposed technique uses a resistor that connects the p-well and deep n-well terminals of the triple-well transistor, leaving the terminals floating instead of conventionally connecting them to the ground and supply voltage. This arrangement exploits a leakage current through a diode formed between the drain/source and p-well of each transistor, thus autonomously setting its bulk potential for increased transconductance, while ensuring its robustness to the process variation. The improved isolation between the p-well and the substrate further improves the gain and noise performance. We provide a theoretical analysis of this floating resistor-based body biasing method and support it with simulation results. For experimental validation, a two-stage cascode LNA was designed and fabricated in 28-nm bulk CMOS. The measurement results show that 3.3–4 dB noise figure (NF) and 19.1–16.1 dB gain are achieved at 24.7–29.5 GHz. To ensure a fair comparison, another identical LNA with the normally expected triple-well biasing was also fabricated. The proposed method reveals a 0.6 dB improvement in minimum NF and an additional $\sim$ 3.5 dB gain without any significant linearity degradation.
1 February 2022 in IEEE Journal of Solid-State Circuits
This article proposes an interleaving switched-capacitor RF digital-to-analog converter (RFDAC) using an edge combiner within the output stage to implicitly triple its effective clock carrier frequency and enable the mm-wave (mmW) operation. Tripling in the output stage allows for increased energy efficiency, which is further improved by employing an edge-combining-based frequency-tripling delay-locked loop (DLL) in the clock generation network. The clock tripling is performed in each slice of the switched-capacitor PA (SCPA), which allows yet another 3 $\times $ frequency reduction for the global clock distribution. Finally, a new layout structure accounts for transmission-line (TL) effects, due to the large physical size of the passive capacitor array. Implemented in 22-nm FD-SOI, the prototype achieves $ {{P_{\mathrm{ out}}}}>21$ dBm, drain efficiency >36%, and system efficiency >22% while operating in the Ka -band at 28 GHz. Modulation at 2.4 Gb/s results in 3.3% EVM and 30.8-dBc adjacent channel leakage ratio (ACLR).
13 June 2016 in Analog Integrated Circuits and Signal Processing