Jeongsup Lee

Jeongsup Lee

Auto-generated profile, based on publicly available information

Jeongsup Lee

EECS Department, University of Michigan, Ann Arbor, MI, USA

Research Focus & Metrics

Academic Career Length

13Years (2014-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
2 October 2019 in IEEE Journal of Solid-State Circuits
Verified
Journal Article
Closed access
JLJeongsup Lee
Jeongsup Lee
SMSatoru Miyoshi
Satoru Miyoshi
MKMasaru Kawaminami
Masaru Kawaminami
DBDavid Blaauw
David Blaauw
DSDennis Sylvester
Dennis Sylvester
MYMakoto Yasuda
Makoto Yasuda
Energy-optimal operation is one of the key requirements of the Internet-of-Things (IoT) applications to increase battery life. In this article, using a combination of dynamic voltage scaling (DVS) and adaptive body biasing (ABB), the energy-optimal operation is achieved with a given fixed operating frequency determined by application demands. Based on the observation that the ratio of leakage power to dynamic power can be an accurate indicator for the optimal operating point, the proposed method dynamically tracks the minimum energy operating points by adjusting supply voltage and body bias with very low hardware and power overhead. A custom dc-dc converter for supply voltage regulation and charge pumps for body bias generation were implemented with the proposed method in a Cortex-M0 processor. Since SRAM is included in the same energy optimization loop as the processor, a custom SRAM was designed to match the processor speed. The design is fabricated in an Mie Fujitsu Semiconductor (MIFS) 55-nm deeply depleted channel (DDC) CMOS and the proposed approach achieves energy consumption within 4.6% of optimal at 1 MHz across five process corners and temperatures from -20 °C to 125 °C. The fabricated processor achieves 6.4 pJ/cycle at 0.55-V and 500-kHz clock frequency.

3 December 2014 in IEEE Journal of Solid-State Circuits
Verified
Journal Article
Closed access
HWHyosup Won
Hyosup Won
TYTaehun Yoon
Taehun Yoon
JHJinho Han
Jinho Han
JLJoon-Yeong Lee
Joon-Yeong Lee
JYJong-Hyeok Yoon
Jong-Hyeok Yoon
HBhyeon min bae
hyeon min bae
This paper describes a low-power 100 Gigabit Ethernet transceiver IC compliant with IEEE802.3ba 100GBASE-LR4 in 40 nm CMOS. The proposed bidirectional full-duplex transceiver IC contains a total of eight 28 Gb/s CDRs. Each CDR lane incorporates phase-rotator-based delay- and phase-locked loop (D/PLL) architecture for enhanced jitter filtering. All the CDR lanes operate independently while sharing a single voltage-controlled oscillator and supporting referenceless clock acquisition. To reduce power consumption, a multidrop clock distribution scheme with single on-chip transmission-line (T-line) and quadrate RX and TX schemes without CML logic gates are incorporated. Embedded built-in self-test modules featuring a random accumulation jitter generator enables bit error rate (BER) and jitter tolerance self tests without any external equipment. The TX featuring a three-tap pre-emphasis provides a variable output swing ranging from 478 mVppd to 1.06 Vppd. RX equalizers employing a continuous-time linear equalizer and a one-tap decision feedback equalizer compensate for the channel loss up to 25 dB at the Nyquist rate. The measured RX input sensitivity for a BER of 10 -12 is 42 mVppd. The proposed IC consumes only 0.87 W at 28.0 Gb/s with a BER less than 10 -15 on PRBS31 testing. The power efficiency of the proposed transceiver is 3.9 mW/Gb/s, which is the best among the efficiencies achieved by recently published 25 Gb/s transceivers.

6 February 2019 in IEEE Solid-State Circuits Letters
Verified
Journal Article
Closed access
TJTaekwnag Jang
Taekwnag Jang
JLJongyup Lim
Jongyup Lim
KCKyojin Choo
Kyojin Choo
SNSamuel Nason
Samuel Nason
JLJeongsup Lee
Jeongsup Lee
DBDavid Blaauw
David Blaauw

8 July 2020 in IEEE Solid-State Circuits Letters
Verified
Journal Article
Closed access
JLJeongsup Lee
Jeongsup Lee
MSMehdi Saligane
Mehdi Saligane
DBDavid Blaauw
David Blaauw
DSDennis Sylvester
Dennis Sylvester
This letter proposes a robust synchronous wide-range clocked level converter (LC) that converts subthreshold input signals to high I/O voltages for ultra-low power (ULP) SoCs. By biasing the circuit using nMOS leakage current, the design offers robust operation across a wide range of low- and high-supply voltages as well as PVT variations. The design was fabricated in 55-nm CMOS process and shows 60.5-fJ ( $V_{\mathrm{ DDH}}=2.5$ V) switching energy, marking a $2.6\times $ improvement over prior works.

1 January 2024 in IEEE Solid-State Circuits Letters
Verified
Journal Article
Closed access
ALAnhang Li
Anhang Li
JLJeongsup Lee
Jeongsup Lee
PMPrashansa Mukim
Prashansa Mukim
BHBrian D. Hoskins
Brian D. Hoskins
PSPragya Shrestha
Pragya Shrestha
MSMehdi Saligane
Mehdi Saligane
This letter presents a fully integrated recursive successive-approximation switched capacitor (RSC) DC–DC converter implemented using an automatic cell-based layout generation in 12-nm FinFET technology. A novel design methodology is demonstrated based on the theoretical analyses of the optimal energy operation of the switched-capacitor (SC) DC–DC converter and directly finds the optimal design parameters from the given input specifications. The converter maintains >75% efficiency across a vast range of output currents and temperatures. Our design targets voltage scaling for applications, such as cryo-computing, cryo-sensing, and parts of quantum computing, to achieve high-system power efficiency.