7 March 2018 in IEEE Journal of Solid-State Circuits
This paper proposes the first feed-forward equalizing transmitter (Tx) which adaptively relaxes impedance matching. Using an on-chip time-domain reflectometer monitor, the Tx accurately detects the impedances of the channel and the receiver (Rx), and then automatically configures its termination impedance to maximize the received signal by optimally relaxing the constraint of impedance matching at the cost of a negligible penalty in signal integrity. The Tx is universally compatible with arbitrary impedances of channels and Rxs, and achieves better performance and power efficiency than the conventional Tx with impedance matching. The proposed Tx was fabricated in 65-nm CMOS technology. The Tx successfully adapted to any combination of a channel impedance of 35-75 Ω and a receiver impedance of 30-200 Ω. When the impedance matching of the Tx is adaptively and optimally relaxed, the eye size and the power efficiency are improved by up to 3.8 times and 2 times, respectively, compared with the conventional Tx. These results verify that the proposed Tx can adapt to various impedances of the channel and the receiver while achieving better performance and power efficiency than the conventional Tx with impedance matching.
30 October 2020 in IEEE Access
This article presents the body channel communication technique that first adopts decision feedback equalisation. For the first time, we characterised post-cursor intersymbol interference of a single-bit pulse response of a human body channel for decision feedback equalisation achieving the first body channel communication faster than 100 Mb/s. In the proposed technique, an 8-tap decision feedback equaliser is utilised at the receiver to compensate for intersymbol interference of the body channel. The experimental results show that the proposed prototype transceiver achieved the highest data rates of 150 Mb/s and 10 Mb/s along 20-cm and about 100-cm body channels, respectively. Compared to the previous best result measured for the same body-channel distance of about 100 cm, the data rate is improved by ten times, showing that the proposed technique can significantly increase the speed of body channel communication.
24 June 2014 in IEEE Transactions on Circuits and Systems I: Regular Papers
This paper presents an approximate closed-form channel model for a wide range of high-speed interconnect designs. Closed-form formulas derived from telegrapher's equation can accurately describe frequency responses of various interconnects, which have hardly been described by simple closed-form formulas, as long as the channels meet clear validity conditions. The formulas also provide a simple and intuitive equivalent circuit representation which allows designers to separately consider the effects of transmitter impedance, receiver termination, and wire attenuation. For a wide range of applications, the relative error of our model is theoretically bounded by the validity conditions. The model's accuracy is verified by comparing the calculated transfer functions against simulation results using the previous method built in SPICE for various interconnect examples from LC-dominant printed-circuit-board interconnects to RC-dominant silicon-interposer interconnects. In addition, the simplicity of our model improves computation time by about 162 times compared to the previous numerical computation method. With this channel model, designers can intuitively and accurately analyze the behavior of interconnects and design trade-offs of a wide range of interconnects without complex numerical simulation.
23 April 2018 in IEEE Transactions on Circuits and Systems II: Express Briefs
This paper presents an intuitive, simple, and widely-applicable approximate closed-form transfer function model for multiconductor transmission lines. Rigorous closed-form transfer functions are derived from the telegrapher’s equation and approximated for a wide range of multiconductor transmission lines that satisfy validity conditions. Theoretical error bounds are also proposed and tightly estimate the approximation errors. The approximate formulas are simple yet accurate, and can be intuitively interpreted by a simple voltage-controlled voltage source circuit model. In demonstration, we show that the proposed model allows designers intuitively to understand and accurately to analyze complex multiconductor transmission lines.
31 December 2016 in Journal of Magnetics