5 February 2018 in IEEE Transactions on Electron Devices
This paper presents a CMOS image sensor (CIS) utilizing a noise-shaping successive-approximation register analog-to-digital converter (SAR ADC) incorporating the delta-readout scheme. While the noise-shaping SAR ADC with a proposed two-tap passive finite-impulse response (FIR) filter improves effective resolution, the delta-readout scheme reduces its power consumption. A prototype 1920 × 1440 pixel CIS was fabricated in a 90-nm CIS process. A single-channel readout SAR ADC occupying an area of 22.4 μm × 715 μm was implemented for reading out 16 columns of pixel array, consuming 437 μW. Owing to the proposed noise-shaping SAR ADC with oversampling ratio of 16, this paper achieves a noise reduction of 14 dB compared with the noise of a conventional SAR ADC. The delta-readout reduces the power consumption of the SAR ADC by 10% due to the high hit rate of the full high definition image format. The measured differential nonlinearity of the ADC is +0.77/-0.54 LSB and the integral nonlinearity is +0.81/-0.5 LSB. The prototype CIS consumes a total power of 64 mW and achieves a dynamic range of 66.5 dB and a figure of merit of 127 μV·nJ at a data rate of 138 Mpixels/s.
17 August 2018 in IEEE Transactions on Circuits and Systems I: Regular Papers
This paper presents three low-power design techniques for successive approximation registers (SAR) analog-to-digital converter (ADC) for bio-potential signal acquisition: skip-reset, delta (Δ) readout with MSB-rounding, and tri-level split monotonic switching. The skip-reset scheme reduces not only reference energy but also digital switching energy for the ADC reset. The Δ-readout process with the proposed MSB-rounding technique shifts the location of the resolvable range using the previous digital code to increase the hit-rate. Finally, the tri-level split monotonic switching scheme minimizes the CDAC switching activity in predictive residue generation for the Δ-readout process. A prototype ADC was fabricated in a 0.18-μm CMOS technology and occupies an active area of 0.17 mm 2 . At a 1.5-V supply voltage and a 1-kS/s sampling-rate with the electrocardiogram signal input, the ADC power consumption could be reduced to 18.5 nW, corresponding to 71% power saving, and owing to the proposed techniques from a conventional SAR ADC consuming 63.5 nW.