24 August 2020 in IEEE Access
In this paper, a miniaturized implantable circularly polarized spiral Planar Inverted-F Antenna (SPIFA) in the UHF (600-800 MHz) band is presented. This antenna is intended for deep implantable devices such as leadless pacemakers and deep brain stimulation (DBS), which facilitates the reception of RF power from an external transmitter. The antenna is electrically small, with a volume of π × 5 mm × 5 mm × 3.2 mm and a diameter of 0.022λ. The performance of the proposed antenna in terms of reflection coefficient, realized gain and axial ratio are assessed when accounting for the effects of operating in different types of human body tissues, different biocompatible materials and different thicknesses and depths of the implanted antenna. Finally, the antenna is prototyped and measured in free space, a phantom model, in a cow’s fat and muscle tissues to validate the simulation results, indicating good agreements. A realized gain around -20 dBm is achieved when operating in 50 mm depth in cow’s muscle tissue while having electrically very small dimensions compared to implantable antennas reported in the literature.
23 August 2024 in IEEE Transactions on Microwave Theory and Techniques
In telecommunication systems, like full-duplex transceivers, simultaneous transmission, and reception demand highly linear components to minimize intermodulation interference. PIN-diode-based RF switches used either independently or as part of a device, can introduce nonlinearity in both on and off states. This article evaluates the impact of the topology on the linearity of PIN-diode-based RF switches and proposes an optimal two-diode arrangement to achieve superior linearity performance. The proposed topology combines the strengths of the series and parallel topologies while mitigating their weaknesses. Owing to its inclusion of two PIN diodes, the proposed topology also leverages the distance between them to further increase the linearity. The presented analysis indicates that having a quarter-wavelength distance between the diodes is key for achieving intermodulation cancellation in the on state, resulting in a 12 dB IIP3 enhancement. In the off state, complete distortion cancellation is more complicated due to additional reflections. The quarter wavelength transmission line was utilized as an impedance transformer to improve linearity by altering the impedance seen by each diode. Detailed analysis, supported by mathematical and experimental results, confirms a 20 dB improvement in IIP3 in the off state. Consequently, the peak IIP3 values, 99 dBm in the on state, and 111 dBm in the off state occur within a narrow bandwidth. The proposed switch maintains an IIP3 of 95 dBm in both states across a wider bandwidth of 1.8–2.6 GHz.
30 May 2024 in IEEE Transactions on Microwave Theory and Techniques
This article presents a novel reconfigurable feed network that allows the switch of antenna arrays across four different polarization states. Different from most previous multipolarization antennas, the reconfiguration is implemented solely in the feed network without disturbing the radiation element. The key enabler is a reconfigurable coupler that switches between two circuit functions—a branch-line coupler or a crossover—through altering the line widths of its parallel branches. This is only made possible by using liquid metals (LMs). A double-pole-double-throw (DPDT) switch, also enabled by LM, is employed to select the input port of the reconfigurable coupler. The switch and the reconfigurable coupler form the reconfigurable feed network, providing four states of excitation to the antenna. The reconfigurable coupler, the switch, and a 2 $\times$ 2 array have been designed and experimentally verified with the LM actuation. As a branch-line coupler, the reconfigurable coupler shows excellent amplitude and phase balance within 0.04 dB ( $\vert\vert S_{{21}}\vert$ – $\vert S_{{31}}\vert\vert$ $<$ 0.04 dB) and 90 $^{\circ}$ at 3.5 GHz, whereas, as the crossover, it has an isolation over 25 dB. The switch exhibits an isolation of 50 dB. The measured peak gain of the array is 14.7 dBic. At 3.5 GHz, the measured axial ratio (AR) associated with the right-hand circular polarization (CP) state is 1.0 dB. The speed of switching and power handling associated with the LM have been discussed. The use of the LM has enabled a unique way of circuit reconfiguration and a full polarization-reconfigurable multifunctional antenna.
20 March 2025 in IEEE Transactions on Microwave Theory and Techniques
In full-duplex telecommunication systems, where simultaneous transmission and reception occur, component nonlinearity imposes strict limits on maximum transmit power. Phase shifters, essential in phased array antennas, often contribute significantly to intermodulation distortion. In this article, an analytical approach is presented for enhancing the linearity of p-i-n diode-based radio frequency (RF) switches in phase shifters by optimizing the impedance seen by p-i-n diodes. An optimal impedance range for each p-i-n diode is identified through theoretical analysis, demonstrating improvements in linearity, as quantified by the third input intercept point (IIP3). Moreover, linearity is shown to increase when p-i-n diodes are arranged in parallel, reducing RF current in the on state, though trade-offs are acknowledged in the off state. To validate these findings, three RF switches with one, two, and four parallel p-i-n diodes, respectively, were designed and implemented using coupler impedance transformers for optimal impedance conversion. It is shown that a highly linear three-bit phase shifter with an IIP3 of 90 dBm and an insertion loss (IL) of 1.4 dB/bit was successfully designed and implemented for a frequency range of 1.9–2.2 GHz, demonstrating the effectiveness of the proposed approach. Compared to conventional p-i-n diode-based switched-line phase shifters, the design achieves an IIP3 improvement of more than 17 dB.
1 July 2021 in AEU - International Journal of Electronics and Communications
8 November 2024 in IEEE Transactions on Microwave Theory and Techniques
Signal distortion caused by passive intermodulation (PIM) poses a significant challenge to modern multicarrier communications and radar systems. This article is concerned with modeling the superposition of reverse PIM products generated by weak nonlinear sources and proposes means of PIM mitigation accordingly. The developed model is experimentally validated using an open-ended coaxial waveguide with a movable iron insert serving as the main PIM source. The study explores PIM interactions from multiple sources and introduces a new circuit comprising three negatively biased p-i-n diodes separated by 60 $^{\circ}$ transmission lines. It substantially reduces reverse PIM by over 30 dB with a minimal footprint compared to previous studies. The potential of this circuit for measuring the reverse PIM phase is explored theoretically and experimentally for the first time, showing trends in agreement with a mean absolute error of 19.49 $^{\circ}$ .