1 November 2021 in Annals of Palliative Medicine
Background: In recent years, the incidence of heart disease has increased and patients are younger. Cardiac rehabilitation training has been proposed to improve the prognosis of patients with heart disease. Cardiac rehabilitation includes moderate-intensity continuous training (MCT) and high-intensity interval training (HIIT). These two training methods have different effects in improving the prognosis of patients. The aim of the present study was to improve reference for patients with cardiac rehabilitation. Methods: English databases, including PubMed, Cochrane Library, and Embase, were searched from the establishment of the database to April 2021 for randomized controlled trials (RCTs) of rehabilitation training at different intensities. RevMan 5.3 was used for the meta-analysis. Results: A total of 8 articles (with a total of 465 patients) were included, including 236 patients in the experimental group and 229 patients in the control group. Different intensities of training had statistically significant differences in peak oxygen uptake [mean difference (MD): 1.21, 95% confidence interval (CI): −0.66 to 3.07, P=0.20] and the left ventricular ejection fraction difference (MD: 2.53, 95% CI: −2.10 to 7.17, P=0.28). Discussion: Cardiac rehabilitation training can effectively improve the patient’s cardiac function indicators and self-care ability, and reduce the incidence of cardiovascular disease (CVD). However, large-sample, multicenter, and long-term RCTs are needed to strengthen the findings of the study.
31 July 2025 in IEEE Microwave and Wireless Technology Letters
This letter proposes a novel structure of mm-wave (mmW) high-linearity voltage-controlled oscillator (VCO), which comprises an 8-GHz VCO and a current/function-reused frequency tripler (FT). Based on the least squares method, a theoretical approach is proposed to determine the optimal varactor value that achieves the maximum linearity using a single-analog control voltage. Implemented in the 65-nm CMOS technology, the high-linearity mmW VCO obtains a $K_{\text {VCO}}$ variation of lower than 5.35% over the frequency range from 23.24 to 25.89 GHz. And with an off-chip phase-locked loop (PLL), a 24-GHz frequency-modulated continuous-wave (FMCW) radar system is developed and measured to verify the proposed VCO.
23 December 2025 in IEEE Microwave and Wireless Technology Letters
An 8.3–43-GHz CMOS low-noise amplifier (LNA) with wideband input matching is presented. A gate–drain transformer feedback combined with a series–shunt resonance network is employed in a complementary common-source (CCS) input stage to achieve a broadband, impedance-stable input, and noise matching. A transformer-loaded cascode output stage is implemented to enhance gain, while a pole-tuning technique is adopted to achieve a broadband gain response. Fabricated in 65-nm CMOS, the LNA achieves a peak gain of 14.7 dB and a 3-dB bandwidth from 8.3 to 43GHz with a fractional bandwidth of 135.3%. Good input matching is maintained across 8–55GHz. The input 1-dB compression point (IP ${}_{\mathrm {1dB}}$ ) ranges from –14.3 to –9.3 dBm. A minimum noise figure (NF) of 3.47 dB is measured, and the power consumption is 25.9 mW under a 1.2-V supply.
23 February 2026 in IEEE Journal of Solid-State Circuits
This article presents a reconfigurable dual-path dual-band low noise amplifier (LNA) for fifth generation (5G) millimeter-wave (mmW) communications. A novel band-switching input matching architecture based on the cross-connected transistors is proposed to achieve optimal dual-band input matching and $g_{m}$ -boosting. This architecture allows the dual-band input transistors to share a tri-coupled-transformer-based input matching network (MN) while maintaining independent output paths. Furthermore, an 8-shaped transformer-based decoupling interstage MN provides optimal interstage impedance matching in the low-band and high-band modes while sharing the same footprints with negligible performance degradation. In addition, to suppress interference from image bands, a notch filter based on negative resistance is integrated into the output MN. A prototype of the proposed LNA was fabricated in TSMC 65-nm bulk CMOS process with a compact core size of 0.132 mm2. The measurement results show that the proposed LNA covers the n257 and n260 bands, achieving a peak gain of 17.8/17.9 dB at 28/37.1 GHz and image rejection (IR) of 37.4/25.9 dBc at 38.2/28.5 GHz, respectively. The measured noise figure (NF) reaches minimum values of 3.23/3.63 dB at 28/37.8 GHz. Moreover, the power consumptions of the two modes are 19.9 and 21.2 mW, respectively, from a 1.0-V supply voltage.