22 April 2024 in IEEE Transactions on Electron Devices
A novel implementation for electrostatic discharge (ESD) protection is demonstrated, which involves two structures named MOSFET in parallel with diode (MOS-DIO) and MOSFET in parallel with silicon-controlled rectifier (MOS-SCR). The fabricated structures exhibit enhanced robustness enabled through the double silicon-on-insulator (DSOI) technology. The implementation combines a MOSFET in the top silicon film with a diode or a silicon-controlled rectifier (SCR) located in the middle silicon layer. Transmission line pulse (TLP) experiments show that compared with the traditional single nMOS structure, both DSOI MOS-DIO and MOS-SCR exhibit superior current discharge capability with an increase in failure current of up to 39% under the same footprint. The leakage of the proposed structures is also reduced to below 0.2 pA/ $\mu \text{m}$ thanks to the double buried oxide isolation. In addition, both triggering and holding voltages can be flexibly tuned via the positioning of the two shunt devices. Technology computer-aided design (TCAD) simulations were carried out for MOS-SCR to interpret the physical mechanism and predict the performance under different device parameters, including gate length, stacked modes, and ambient temperature.
3 September 2024 in IEEE Transactions on Electron Devices
The impact of the total ionizing dose (TID) on low leakage electrostatic discharge (ESD) protection devices fabricated on the 180-nm double silicon on insulator (DSOI) technology is investigated through experiments and numerical simulations. The devices under tests (DUTs) are MOS-DIO, MOS-SCR, and gate-grounded NMOSFET (GGNMOS). The transmission line pulse (TLP) measurements were carried out before and right after $^{\text{60}}$ Co gamma ray irradiation. The results show that the radiation-induced charges and traps mainly located in the top buried oxide (BOX1) can lead to deterioration of ESD characteristics, such as leakage and triggering voltage. After being irradiated to a dose of 300 krad(Si), the leakage of GGNMOS increases by about three orders of magnitude, and in addition, its snapback characteristic vanishes. Radiation hardness on DSOI-based ESD devices is analyzed based on experiment and simulation results, which implies that the negative voltage on back-gate electrode can mitigate the deterioration of ESD characteristics caused due to irradiation.
2 March 2026 in IEEE Transactions on Nuclear Science
The synergistic effects of the total ionizing dose (TID) and single-event upset (SEU) are investigated in a 0.18-μm double silicon-on-insulator (DSOI) static random access memory (SRAM), and the impacts of top silicon-layer thickness (TSOI1) and back-gate bias are discussed. Experimental results show that the TID irradiation significantly enhances the SEU cross-section; specifically, at LET = 86.1 MeV·cm²/mg, a TID of 1000 krad(Si) increases the SEU cross-section by a factor of 2.7. Thanks to reduced charge collection, a 60.7% decrease in SEU cross-section is observed under 181Ta35+ irradiation when TSOI1 is reduced from 65 nm to 45 nm. Moreover, a negative back-gate bias enhances the radiation hardness of the SRAM, achieving a 71% reduction in the SEU cross-section under 181Ta35+ ion exposure following a TID of 1000 krad(Si). Consequently, an optimized biasing scheme is proposed to balance the trade-offs between radiation hardness and key circuit performance metrics, including access time, area, and power consumption. The underlying physical mechanisms are further elucidated through TCAD and HSPICE simulations.
1 January 2026 in IEEE Transactions on Nuclear Science
1 October 2024 in Journal of Instrumentation