24 January 2017 in IEEE Transactions on Instrumentation and Measurement
This paper reports recent progress in developing a new asynchronous digital phase comparator for the precision measurement of phase difference of voltage ratio devices and calibration of functional elements of phasor measurement units (PMUs) calibrator. The phase error of the proposed digital comparator is below 300 nrad at 50 Hz and 100 μrad at 100 kHz with applied voltages ranging between 500 mV and 3 V, whereas the phase error of cables and connectors was estimated to be 4 μrad at 1 MHz. Besides resistive dividers, the phase comparator has been employed for the characterization of frequency behavior of phase difference between the output and input of voltage and transconductance amplifiers for a PMUs calibrator. The system can also be an important tool for phase-frequency characterization of devices employed for specific wideband power measurements.
7 December 2016 in IEEE Transactions on Applied Superconductivity
This paper presents recent advances in the application of binary-divided 1 V array, consisting of 8192 intrinsically shunted SNIS overdamped Josephson junctions (JJs), for the synthesis of stepwise waves with quantum accuracy. The maximum output voltage is ensured by opportunely driving the subsections of the SNIS array by means of three states bias-current setpoints to the Shapiro steps n = 0, ±1 or n = ±2, respectively. Reconfigurable digital modular electronics has been designed to bias individually each of the 13 subsections of the SNIS array. A two-stage closed cycle refrigerator equipped with LF and RF electrical lines is employed for cooling-down the SNIS array for temperatures ranging from 3.6 K to above 7 K. Stepwise sine waves with rms amplitude ranging from 1 to 2 V using the first (n = 1) and second (n = 2) Shapiro steps, different temperatures and bias-current setpoints have been synthesized up to the kHz range. The synthesized waves have been recorded and analyzed by a high-precision differential sampling system. We report the results of the first characterizations carried out with the new multibit current source and an improved version of the sample holder designed to optimize the heat dissipation of the SNIS array for operation in cryocooler setups.
26 April 2024 in Measurement
We report on the realization and preliminary validation of a quantum-based sampling power standard, based on a 1 V Programmable Josephson Voltage Standard (PJVS). The PJVS has been integrated into an existing sampling power standard along with a new synchronous multiplexer. Measurement scenarios for voltage and power measurements have been implemented and internally validated. Results of the measurement comparison against the Italian primary electrical power standard at 53 Hz agree well within the respective uncertainties, and did not exceed 15 μW/VA from 120 V to 240 V and 5 A and any power factor. Likewise, measurements of alternating voltage up to a few kilohertz show good agreement when compared against AC/DC voltage transfer method. The article illustrates the quantum power standard and its main constituents, measurement scenario, comparison results and discussion, along with a preliminary estimation of the uncertainty budget.
6 July 2023 in Measurement
3 December 2021 in IEEE Transactions on Instrumentation and Measurement
A power frequency modular digital sampling power standard (DSPS) is developed and extensively characterized at Istituto Nazionale di Ricerca Metrologica (INRiM) for accurate electric power measurement with a relative uncertainty (k = 1) better than 8 μW/VA. The calibration strategy employed allows to link its key constituents to electrical quantum standards with a relative uncertainty (k = 1) within 3 × 10-6. Comparison measurements against the national power standard at 53Hz agree well within the respective measurement uncertainties and did not exceed 10 μW/VA at 240V and 5A and any power factor. The various novelties introduced make the DSPS a versatile metrological grade measurement setup, which lends well to further improvements and accurate evaluation of electrical parameters involved in power quality measurements. The paper reports the standard, its traceability chain and calibration strategy, comparison measurements and uncertainty budget.