29 December 2022 in IEEE Access
This paper presents a high-accuracy multifunction chip (MFC) with amplitude and phase control in X-band. The MFC is designed with a common leg structure and incorporates a 6-bit attenuator (ATT), a 6-bit phase shifter (PS), two gain compensation amplifiers (GCAs), three single pole double throw switches (SPDTs), and fourteen logic control circuits. However, cascading these blocks causes the change of the terminal impedances of the ATT and PS, which is detrimental to the accuracy. To solve this problem, the extra tunable interstage matching networks (IMNs) are introduced between each ATT and PS cell to alleviate the terminal impedance changes. The compensation capacitances are also applied to ATT to reduce the insertion phase shift. The receive and transmit modes switching is achieved by using four SPDTs. In addition, the resistance feedback is used in GCAs to compensate for passive losses and provide gain to the MFC. To validate the design scheme, the proposed MFC is fabricated in 0.15-μm GaAs pseudomorphic high-electron-mobility transistor (pHEMT) process. The measured results show that the MFC has excellent accuracy due to the introduction of IMNs. In the range of 8-11 GHz, the measured maximum root-mean-square (RMS) amplitude error of the MFC is less than 0.28 dB, and the maximum RMS phase error is less than 3.3°. Moreover, the MFC is achieved with a compact layout of 4.3 mm × 2.85 mm. Excellent performance and compact size make the MFC greatly potential in spaceborne phased array applications.
23 May 2025 in IEEE Open Journal of Vehicular Technology
In high-speed mobile scenarios, Orthogonal Time Frequency Space (OTFS) effectively addresses the Doppler frequency shift. Channel coding enhances the performance of OTFS systems by adding redundancy and error correction capabilities. However, existing coding schemes still face limitations when dealing with complex conditions such as highly dynamic channel variations, delay spread, and Doppler effects. This paper proposes a Low-Density Parity-Check (LDPC)-Hadamard code to assist OTFS in combating complex channel conditions, thereby improving data transmission efficiency. In particular, the LDPC-Hadamard code leverages the sparsity of LDPC and the orthogonality of Hadamard codes to address the issue of rapidly varying channels in OTFS systems. Additionally, a low-complexity quasi-cyclic LDPC code construction algorithm is proposed to decrease the coding complexity. Otherwise, a Log-Likelihood Ratio Belief Propagation (LLR-BP) decoding algorithm is introduced, which reduces the computational complexity. Therefore, the proposed coding and decoding methods enable the OTFS to achieve better performance in low SNR conditions. Compared to conventional quasi-cyclic LDPC schemes, the proposed LDPC-Hadamard code-assisted OTFS system exhibits a 0.2 dB SNR gain and achieves a lower BER of $10^{-6}$ at 1.1 dB SNR, demonstrating enhanced robustness against Doppler-induced impairments in highly dynamic channels.
12 December 2025 in IEEE Transactions on Wireless Communications
The distributed deep learning architecture between front-deployed sensors and edge-deployed gateways attracts increasing interest. However, the inference performance of distributed deep models is also impacted by the delivery loss of intermediate representation in the wireless link, especially in the harsh industrial fading environments. Traditional communication systems usually focus on transmission errors at bit level, which treat all bits in the packets equally and fail to suit the varying importance in distributed deep models, which urges the essential evolution of the communication method to form a joint co-design paradigm for distributed deep models. This article then proposes to optimize the Mean Time To First Failure (MTTFF) of wireless link instead of traditional bit error rate, which enables a guaranteed transmission window. This paper first derives the analytical model of MTTFF under MIMO systems, then utilizes the kernel mixture distribution to obtain a closed-form solution of MTTFF, which forms a optimization algorithm minimizing the transmitted power while achieving the aiming MTTFF. Extensive reallife experiments show more than 70% satisfaction rate of MTTFF, which leads to more than 10 times higher inference accuracy than the original deep model.