Laser-assisted atom probe tomography (APT) and high-resolution dark-field electron holography (HR-DFEH) were performed to investigate the composition of a polar [0001] GaN/AlxGa1 − xN/InyGa1 − yN light emitting diode. In particular, the III-site fraction of both AlxGa1 − xN and InyGa1 − yN alloys was studied adopting a comparative approach. HR-DFEH allows mapping the projected strain with a subnanometer spatial resolution which is used for the calculation of the two-dimensional alloy composition distribution. APT provides three-dimensional alloys composition distribution with a nanometer spatial resolution. However, here we reveal that important inaccuracies affect local composition measurements. A Ga-poor composition is obtained in high DC-electric field regions. Moreover, such inaccuracies may be locally enhanced where the [0001] pole intersects the surface of the analyzed specimen, leading to a lower fraction of Ga measured. III-site fractions closer to the nominal values were measured at low field conditions. Ga loss is thought to be due to preferential DC field induced evaporation of Ga ions between laser pulses. This is explained in terms of formation of a metallic layer on the tip surface during APT analysis, where weak Ga-Ga bonds are formed, promoting the loss of Ga at high field conditions.
Gaseous phase epitaxy from metal organic compounds is used to obtain a low-temperature injection laser with an active region based on In0.5Ga0.5As/GaAs quantum dots. Optimizing the growth conditions a
18 July 2023 in Journal of Vacuum Science & Technology A
Bulk crystals of β-Ga2O3 were successfully grown by the edge-defined film-fed growth method. The crystalline quality of the obtained crystals was analyzed by the method of x-ray diffractometry. The full width at half maximum of the rocking curve was about 72 arcsec. The optical bandgap was determined by analyzing the optical transmission spectra and amounted to 4.7 eV. The hot disk method was used to obtain the thermal conductivity of the sample along the [001] direction in the temperature range from 30 to 120 °C. The maximum value of thermal conductivity obtained at 30 °C was 9.25 W/(m K).
Raman scattering spectroscopy is used to study the process of selective oxidation of Al0.97Ga0.03As layers. Stresses arising in GaAs/(AlGa)xOylayers as a result of selective oxidation under...
We study a disorder-induced transformation of the resonant optical reflection from a nearly periodic system of quasi-2D excitons in the InGaN quantum wells arranged as a resonant Bragg structure (RBS). We show that there is a critical deviation from the exact periodicity when the reflection by a single super-radiant exciton–polariton mode is transformed into a multimode spectrum. This critical disorder appears to be inversely proportional to the number of periods in the RBS. Using a numerical model which describes the experimentally observed optical spectra, we found the critical standard deviation from exact periodicity to be 1.76%, 1.0%, and 0.45% for InGaN-based RBS with 60, 100, and 200 periods, respectively.
1 January 2021 in IOP Conference Series: Materials Science and Engineering
High electron mobility transistors (HEMTs) technologies based on AlGaN/GaN and InAlN/GaN heterostructures have been developed. The research focused on influence of epitaxial growth conditions and buffer doping profiles on electrical properties HEMTs. An output power density of 4W/mm at 17 GHz was demonstrated for InAlN/GaN HEMTs and 7W/mm at 10 GHz for AlGaN/GaN HEMTs.