Boyu Zhang

Boyu Zhang

Auto-generated profile, based on publicly available information

Boyu Zhang

State Key Laboratory of Spintronics, Hangzhou International Innovation Institute, Beihang University, Hangzhou, China

Research Focus & Metrics

Academic Career Length

10Years (2017-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
17 July 2026 in Science Advances
Verified
Journal Article
Open access
CXChen Xiao
Chen Xiao
WCWenlong Cai
Wenlong Cai
HZHongchao Zhang
Hongchao Zhang
DMDinghao Ma
Dinghao Ma
KCKaihua Cao
Kaihua Cao
WZWeisheng ZHAO
Weisheng ZHAO
Ultrafast switching of magnetic tunnel junctions (MTJs) is essential for future high-bandwidth memory and in-memory computing. However, state-of-the-art electrical switching of MTJs remains constrained to hundreds of picoseconds, leaving a substantial gap between memory and processors. Here, we experimentally demonstrate field-free switching of three-terminal MTJs using picosecond electrical pulses driven by spin-orbit torque (SOT), surpassing the speed limit by an order of magnitude. We further use voltage-gated (VG) effect to probe SOT switching mechanisms over wide pulse-width ranges and identify a nonmonotonic VG-SOT efficiency. While the efficiency is pronounced under long-pulse excitation, it diminishes in the subnanosecond regime but reemerges as the pulse width scales down to 13.2 ps, yielding an energy consumption about 30 fJ per bit. Micromagnetic analysis reveals that, from dc to picosecond timescale, the dominant magnetization switching dynamics evolve from thermally activated reversal to incoherent precession to coherent precession. These results establish picosecond VG-SOT as a pathway toward ultrafast and energy-efficient memory and logic.

1 August 2017
Verified
Conference Paper
Closed access
WCWenlong Cai
Wenlong Cai
KCKaihua Cao
Kaihua Cao
MWMengxing Wang
Mengxing Wang
SPShouzhong Peng
Shouzhong Peng
JZJiaqi Zhou
Jiaqi Zhou
WZWeisheng ZHAO
Weisheng ZHAO
Perpendicular magnetic tunnel junctions (MTJs) based on MgO/CoFeB structures are of particular interest for spin-transfer torque magnetic random access memories (STT-MRAMs). However, their major challenges of combining both a large tunnel magneto-resistance ratio (TMR) and a low junction resistance, a strong interfacial perpendicular magnetic anisotropy (PMA) for the high thermal stability and a low STT switching critical current density are still to be met. In this paper, we show our recent progress in studying the pertinence of capping layers to several principal spintronic effects such as PMA, TMR and Gilbert damping. And we predict and experimentally prove the performance optimization the by the interfacial property tuning of heavy metal/CoFeB.

1 July 2023 in Review of Scientific Instruments
Verified
Journal Article
Open access
PDF file
HCHouyi Cheng
Houyi Cheng
BZBoyu Zhang
Boyu Zhang
SESylvain Eimer
Sylvain Eimer
YLYongshan Liu
Yongshan Liu
YXYong Xu
Yong Xu
WZWeisheng ZHAO
Weisheng ZHAO
The study of interface spin effects in spintronic multilayer films requires distinguishing the effects generated by different interfaces. However, testing in atmospheric conditions requires a capping layer to protect the films, which introduces new interfaces and limits the study of interface spin-dependent effects. To address this challenge, we have developed an integrated ultra-high vacuum cluster system that includes magnetron sputtering equipment, ion irradiation equipment, and time-resolved magneto-optical Kerr effect (TR-MOKE) equipment. Our sputtering system integrates 12 cathodes in a single chamber, allowing the co-sputtering of four targets. The ultimate vacuum can reach 1 × 10−10 mbar, and the deposition resolution of 0.1 nm can be achieved. Ion irradiation equipment can ionize to produce He+, and by screening and accelerating the implantation of He+ into multilayer films, ion scanning is realized, and up to 30 keV energy can be applied to the films. The TR-MOKE equipment can detect ultra-fast magnetic dynamics processes in vacuum conditions, and its external magnetic field can be rotated 360°. Our vacuum cluster system connects the three subsystems, allowing in situ film deposition, regulation, and characterization. By accurately detecting the effects of different layers, the system can distinguish the interface effects of multilayers. Experimental results demonstrate that the three subsystems can work independently or coordinate to observe the interface effects of multilayers.

15 December 2021
Verified
Conference Paper
Closed access
ZYZexin Yan
Zexin Yan
ZSZihan Sun
Zihan Sun
BZBoyu Zhang
Boyu Zhang
Chi MaChi Ma
Chi Ma
JLJiangtao Li
Jiangtao Li
In the power system, air arc faults are very common, in order to study the air arc characteristics, this paper mainly builds an arc generator power module and measures the output voltage waveform. And using the power module and the stepper motor based arc pulling device to build AC air arc generator, which can realize the simulation of AC air arc fault with different arc spacing for different loads under 380 V AC power supply. In order to carry out practical verification, this paper in the 40 Ω, 33 Ω, 20 Ω under the three load AC air arc fault experiments, record the arc voltage and current waveform and analysis, the AC air arc has the following characteristics: different load AC arc have obvious zero rest phenomenon; the voltage amplitude when the arc is lit is higher than it when off; the same power supply, the heavier the load, the higher the arc current. Due to the existence of arc resistance, the arc current is less than the normal operating current; the power consumed to maintain the stable burning of the arc is not large compared to the power of the circuit itself, and the series AC arc fault is easy to maintain. In this paper, it is experimentally concluded that the AC arc has the above properties to provide a basis for further research on the properties of the AC air arc.

16 February 2026 in Applied Physics Letters
Verified
Journal Article
Closed access
RXRui Xu
Rui Xu
CXChen Xiao
Chen Xiao
XZXiangyu Zheng
Xiangyu Zheng
RXRenyou Xu
Renyou Xu
XNXiaobai Ning
Xiaobai Ning
JWJiaqi WEI
Jiaqi WEI
Ultra-fast magnetization switching triggered by a single femtosecond laser pulse has gained significant attention over the last decade for its potential in low-power consumption, high-speed memory applications. However, this phenomenon has been primarily observed in Gd-based ferrimagnetic materials, which are unsuitable for storage due to their weak perpendicular magnetic anisotropy (PMA). In this work, we demonstrated that applying a single laser pulse and an in-plane magnetic field can facilitate magnetic switching in a Pt/Co/Pt ferromagnetic trilayers stack within a specific laser power window. To further understand this phenomenon, we introduce a Cu layer to accelerate the re-establishment time of the anisotropy field of Pt/Co/Pt trilayers, which leads to bullseye-patterned magnetic switching. We have mapped phase diagram for these phenomena, and through micromagnetic simulations, we have determined that these switchings are influenced by thermal anisotropy torque, which can be modulated through PMA. These findings indicate that single-shot optical precessional magnetization reversal is feasible in a broader range of materials, opening avenues for the development of optical-magnetic memory devices.

15 May 2023
Verified
Conference Paper
Closed access
SESylvain Eimer
Sylvain Eimer
HCHouyi Cheng
Houyi Cheng
PVPierre Vallobra
Pierre Vallobra
BZBoyu Zhang
Boyu Zhang
WZWeisheng ZHAO
Weisheng ZHAO
The magnetic properties in Pt/Co and Pt/Co/X/Pt multilayers (with X= different caping materials), such as perpendicular magnetic anisotropy (PMA), are of particular interest for spintronic devices. In particular, it is important to obtain a strong PMA on the flexible substrate in the field of wearable devices and structural health monitoring. However, the different stack structures and growth conditions influence the magnetic properties of the film. Here, we investigate the magnetic properties in Pt/Co/Pt and Pt/Co/X/Pt structures deposited by sputtering with different substrates (hard and flexible), layer thicknesses, different deposition temperatures of the buffer layer, different capping layers, insertion of a thin interlayer and irradiation by He+ ions. We exhibite conditions for better crystallinity, enhanced PMA, homogeneous domain wall motion and stronger DMI. The experimental results also show that the optimized film conditions can also yield strong PMA on the flexible substrate.