In this paper, AlGaN/GaN high-electron mobility transistors (HEMTs) with different fin configurations are fabricated and analyzed. Through S-parameter measurements and modeling of the designed devices, a detailed RF investigation on small-signal model parameters is performed under different biasing conditions. Good agreements between measured and simulated scattering parameters up to 40 GHz illustrate the validity and accuracy of the model. The influence of different fin structures on model parameters and linearity improvement is examined, and this can help to improve the frequency characteristics of fin structure by optimizing the fin length, fin width, and trench width. The significant linearity of Fin-HEMTs is confirmed by the analysis of the model parameters, which is the first time to study the small-signal characteristic of AlGaN/GaN Fin-HEMTs in detail.
2 January 2023 in IEEE Microwave and Wireless Technology Letters
This letter describes a design of a 3.3–3.6-GHz GaAs heterojunction bipolar transistor (HBT) power amplifier (PA) with high linearity and temperature insensitivity for the fifth-generation (5G) of new radios (NRs). By involving a multi-feedback branches bias circuit, the voltage at the feedback node of the bias circuit can achieve dynamic self-tuning to stabilize the base voltage as the amplifier’s input power grows and stabilize the bias current as the temperature increases as well. A three-stage common source structure PA in the form of a monolithic microwave integrated circuit (MMIC) is designed using a multi-feedback branch bias circuit with a size of 1.5 $\times$ 1.2 mm. Measured with continuous wave (CW) signals, the output 1-dB compression point at 3.3–3.6 GHz is 34 dBm. The linearity of the PA is also evaluated using a 5G-NR 100-MHz 64-quadratic-amplitude modulated (QAM)-orthogonal frequency division multiplexing (OFDM) signal with a 7-dB peak-to-average-power ratio (PAPR). The proposed PA achieves an adjacent channel power ratio (ACPR) less than $-$ 49.5 dBc at an average power of 28 dBm with a power-added efficiency (PAE) of 20% without the use of digital pre-distortion (DPD). In the temperature range of $-$ 40 $^{\circ}$ C to 120 $^{\circ}$ C, the variance of bias current, small signal gain, PAE, output power at 1-dB compression point (OP1dB), and ACPR is relatively minor. This design is ideally suited for 5G communication systems due to its high linearity and temperature insensitivity.
4 November 2022 in IEEE Transactions on Electron Devices
In this work, a new small-signal model (SSM), which is called the distributes intrinsic subdevice model (DISDM), is established for AlGaN/gallium nitride (GaN) Fin-like high-electron mobility transistors (HEMTs) according to the device structure feature. Perfect agreements between the measured and simulated scattering parameters (S-parameters) illustrated the validity of the DISDM and the accuracy of parameters extracted from the new model. Then, the characteristics of Fin-like HEMTs are analyzed using the DISDM theoretically. Different from the traditional model, the DISDM can accurately show the characteristics of the Fin-like HEMTs, especially the “double-peak” of the intrinsic transconductance. Compared with the planar HEMTs, the Fin-like HEMTs exhibit a higher linearity in direct current and small-signal parameters. For Fin-like HEMTs with different recess depths and duty ratios, the variation of the small-signal parameters and the linearity of devices were characterized to evaluate the performance of devices and optimize the process in the end.
27 September 2022 in IEEE Microwave and Wireless Technology Letters
In this letter, a K -band high-efficiency power amplifier (PA) design using modified resistive-reactive hybrid continuous modes (HCMs) is presented. These modified modes can increase the real part of the fundamental impedance when the second harmonic impedances become resistive-reactive. This helps to reduce the impedance transformation ratio when applying modified modes in transistors with a small optimal impedance ( R $_{\mathbf{opt}}$ ), as well as making HCMs more practical in these transistors. For K -band Satcom downlink applications, by using this method, combined with a compact output matching network (OMN) design, high performance, and high integration PA can be achieved. A 2 $\times$ 1.2 mm GaAs pHEMT PA operating at 17–24 GHz was designed and fabricated to verify the theory. Continuous wave measurements show that the saturation output power is greater than 0.5 W and an average power-added efficiency (PAE) of 42%.
The role of device modeling in RF circuit has received increased attention across a number of disciplines in recent years. Consequently, there are higher requirements on the accuracy of the model. Therefore, this paper intends to discuss the way to build the Angelov Model of the Gallium Nitride (GaN) based high electron mobility transistors (HEMTs). For the classic Angelov Model, there are many parameters to describe the trace about Ids curves. With these parameters, the accuracy of the model can be ensured. However, for the Ids curve, one of the main obstacles is that the classic Angelov Model can hardly describe its accuracy, especially when the gate voltage is lower than the knee voltage because of some sensitive parameters is regarded as constant. In order to solve the obstacle, a modified Angelov Model changes the value of two parameters which are sensitive for the output Ids curve is proposed in this paper. Fitting the formula according to the value of the parameter, finally, the accuracy of the curve fitting can be improved, and the error can be reduced to 1 %.