Humberto Miguel Foronda

Humberto Miguel Foronda

Auto-generated profile, based on publicly available information

Humberto Miguel Foronda

Materials Department, University of California 1 , Santa Barbara, California 93106, USA

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 September 2021 in AIP Advances
Verified
Journal Article
Open access
PDF file
AAAbdullah S. Almogbel
Abdullah S. Almogbel
CZChristian Zollner
Christian Zollner
BSBurhan SaifAddin
Burhan SaifAddin
MIMichael Iza
Michael Iza
JWJianfeng Wang
Jianfeng Wang
JSJames S. Speck
James S. Speck
The impact of AlGaN growth conditions on AlGaN:Si resistivity and surface morphology has been investigated using metalorganic chemical vapor deposition. Growth parameters including growth temperature, growth rate, and trimethylindium (TMI) flow have been systematically studied to minimize the resistivity of AlGaN:Si. We observed a strong anticorrelation between AlGaN:Si conductivity and growth temperature, suggesting increased silicon donor compensation at elevated temperatures. Secondary ion mass spectrometry and positron annihilation spectroscopy ruled out compensation by common impurities or group-III monovacancies as a reason for the observed phenomenon, in contrast to theoretical predictions. The underlying reason for AlGaN:Si resistivity dependence on growth temperature is discussed based on the possibility of silicon acting as a DX center in Al0.65Ga0.35N at high growth temperatures. We also show remarkable enhancement of AlGaN:Si conductivity by introducing TMI flow during growth. A minimum resistivity of 7.5 mΩ cm was obtained for n-type Al0.65Ga0.35N, which is among the lowest reported resistivity for this composition.

30 November 2020 in Applied Physics Letters
Verified
Journal Article
Closed access
PDF file
HFHumberto M. Foronda
Humberto M. Foronda
DHDaniel A. Hunter
Daniel A. Hunter
MPMike Pietsch
Mike Pietsch
LSLuca Sulmoni
Luca Sulmoni
AMAnton Muhin
Anton Muhin
MKMichael Kneissl
Michael Kneissl
In this work, the growth and conductivity of semipolar AlxGa1−xN:Si with (11-22) orientation are investigated. AlxGa1−xN:Si (x = 0.60 ± 0.03 and x = 0.80 ± 0.02) layers were grown with different SiH4 partial pressures, and the electrical properties were determined using Hall measurements at room temperature. The aluminum mole fraction was measured by wavelength dispersive x-ray spectroscopy and x-ray diffraction, and the Si-concentration was measured by wavelength dispersive x-ray spectroscopy and secondary ion mass spectroscopy. Layer resistivities as low as 0.024 Ω cm for x = 0.6 and 0.042 Ω cm for x = 0.8 were achieved. For both aluminum mole fractions, the resistivity exhibits a minimum with the increasing Si concentration, which can be explained by compensation due to the formation of cation vacancy complexes at high doping levels. The onset of self-compensation occurs at larger estimated Si concentrations for larger Al contents.

17 May 2019 in Japanese Journal of Applied Physics
Verified
Journal Article
Open access
PDF file
HFHumberto Miguel Foronda
Humberto Miguel Foronda
SGSarina Graupeter
Sarina Graupeter
FMFrank Mehnke
Frank Mehnke
JEJohannes Enslin
Johannes Enslin
TWTim Wernicke
Tim Wernicke
MKMichael Kneissl
Michael Kneissl
The growth mechanisms during metalorganic vapor phase epitaxy (11-22) oriented Al x Ga1-x N with x ∼ 0.80 on m-plane sapphire are studied with the intention of mitigating the expansion of misoriented grains, composed of the (1-10-3) crystal orientation and achieving a flat surface with only the (11-22) orientation. An increase in reactor pressure, metalorganic supply, and V/III ratio led to a decrease in the grain density from 1.0 × 109 cm−2 to 1.5 × 107 cm−2. By comparing different growth regimes, we found that the main factor suppressing the growth of the (1-10-3) orientation and decreasing the grain density in the AlGaN layers is the growth rate, which decreased with increasing reactor pressure, MO supply, and V/III ratio due to increasing pre-reactions in the gas phase. To mitigate pre-reactions even with lower growth rates, growth conditions with higher total flow and lower TMAl flow were chosen, yielding low growth rates of 0.13 μm h−1 and a grain density of 3.0 × 107 cm−2 at an aluminum mole fraction of 84%. To allow the growth of thick LED heterostructures we demonstrated that such a buffer can be overgrown with higher growth rate AlGaN, yielding a low grain density of 1.0 × 106 cm−2 and a smooth morphology with a rms roughness of 2.5 nm by avoiding misoriented crystal propagation during nucleation.

5 July 2021 in Microscopy and Microanalysis
Verified
Journal Article
Open access
PDF file
LSLucia Spasevski
Lucia Spasevski
BBBen Buse
Ben Buse
Paul R. EdwardsPaul R. Edwards
Paul R. Edwards
DHDaniel A. Hunter
Daniel A. Hunter
JEJohannes Enslin
Johannes Enslin
Robert MartinRobert Martin
Robert Martin
Wavelength-dispersive X-ray (WDX) spectroscopy was used to measure silicon atom concentrations in the range 35–100 ppm [corresponding to (3–9) × 1018 cm−3] in doped AlxGa1–xN films using an electron probe microanalyser also equipped with a cathodoluminescence (CL) spectrometer. Doping with Si is the usual way to produce the n-type conducting layers that are critical in GaN- and AlxGa1–xN-based devices such as LEDs and laser diodes. Previously, we have shown excellent agreement for Mg dopant concentrations in p-GaN measured by WDX with values from the more widely used technique of secondary ion mass spectrometry (SIMS). However, a discrepancy between these methods has been reported when quantifying the n-type dopant, silicon. We identify the cause of discrepancy as inherent sample contamination and propose a way to correct this using a calibration relation. This new approach, using a method combining data derived from SIMS measurements on both GaN and AlxGa1–xN samples, provides the means to measure the Si content in these samples with account taken of variations in the ZAF corrections. This method presents a cost-effective and time-saving way to measure the Si doping and can also benefit from simultaneously measuring other signals, such as CL and electron channeling contrast imaging.