Nanostructured copper oxide films were obtained by the method of chemical synthesis from solutions (SCS) and exposed to post-growth rapid thermal processing (RTP) in air at different temperatures to study the influence of annealing temperature on morphological, chemical, structural and sensing properties. Controlled modification of surface morphology, in the particular size of nanostructures, crystallinity and phase can be achieved by RTP, which is preferred due to saving of energy budget nowadays. Detailed physico-chemical analysis of the films was performed using the scanning electron microscopy (SEM), X-ray diffraction (XRD), Raman and energy dispersive X-ray (EDX) techniques. Sensors based on the copper oxide nanostructured films after RTP for 30 s only were tested with 100 ppm hydrogen gas at an operating temperature range from 250 ºC to 350 ºC. The difference in the response to 100 ppm hydrogen gas of the sensors based on thermally processed films at different temperatures was determined. We also noted that the change in the response of the sensing structure is correlated with its surface morphology controlled by RTP regime with a short duration. A detection mechanism to hydrogen gas has been proposed as well.
In this work it was investigated the reliability to ionizing radiation of Eu-doped ZnO nanostructured films functionalized with Pd. Morphological, sensorial and electrical properties of sensors were studied initially, after irradiation and after 6 months to observe the influence of irradiation.
Gas sensors are of major importance in today's industrial, chemical, agricultural, energy and household fields, and their development for general consumer use is an area of growing interest. This study explores the development and hydrogen sensing performance of CuO nanostructures synthesized via a cost-effective chemical solution method. The nanostructures, composed of copper oxide granules uniformly coated with nickel nanoparticles, were deposited on a glass substrate and thermally treated using rapid thermal annealing (RTA) to minimize defects. The resulting sensors exhibited high hydrogen sensitivity, with responses of 60-70% at elevated temperatures of 300 °C and 350 °C. The uniform deposition of Ni on CuO played a critical role in enhancing both sensitivity and selectivity towards hydrogen gas, while minimizing interference from other gases such as acetone, methane, and ammonia. The sensor demonstrated rapid response and recovery times, further confirming its potential for efficient hydrogen gas detection. These findings suggest that CuO nanostructures offer a promising, cost-effective solution for hydrogen gas sensing applications, particularly in safety-critical environments where hydrogen leaks need to be rapidly detected.