The advantages of optical fiber sensors, including fiber bragg grating (FBG) sensors, e.g. greater sensitivity, immunity to electromagnetic interference (EMI) and radio frequency interference (RFI), versatility, reliability, compatibility to optical communication and telemetry, reduced cost, reduced size, and reduced weight have been very well known. In particular, the FBG sensors have been widely utilized in many fields such as in structural health monitoring, oil and gas, civil industry, medical and space equipment. In this paper we develop a model of FBG sensors embedded fiber optic communication (FOC) system by using OptiSystem v.18. The bit error rate (BER) and Q-factor analysis as results of the effect of two FBG sensors on telecommunication channels, in which the sensors are integrated into a single fiber optic communication (FOC) with 80 km of fiber optic length. The results show that even with 2 sensors embedded in FOC system, the min BER and max Q factor of the system are still in good conditions with values of 4.35x 10-7 and 4.87 respectively.
In long-haul communication, fiber optic cable plays an important role as transmission medium. The C-Band is the typical spectrum used in common optical link implementation, especially for long-range. Generally, dense wavelength division multiplexing (DWDM) uses specific wavelength spectrum based on grid stated in ITU-T G.694.1 recommendation, in which it is proposed to acquire several wavelengths to be used as the channels in the system of DWDM communication-based sensor network. In this paper, C-band DWDM channel determination method is presented. The selected DWDM channels are determined by considering lower attenuation and chromatic dispersion in the G.652.D-based fiber optic from Corning SMF-28 fiber optic technical datasheet towards entire wavelength in C-Band area, thus the optimum channels could be discovered. As conclusion, our research found the attenuation parameter has much more significant effect to Q-factor and BER values compared to the chromatic dispersion effect and the top-five most optimized channels are listed.
This research presents the results of laboratory nonlinear characterization of a diaphragm-bonded FBG sensor under coupled pressure–temperature loading. The experiments were conducted using a laboratory-scale pressure–temperature simulator over a pressure range of 0–2.0 MPa and a temperature range of 5–50°C, followed by combined pressure–temperature testing. The sensor’s response was found to be nonlinear. Polynomial models (quadratic or 3rd-order) consistently yielded better results than linear models. Local sensitivity varied with both pressure and temperature, ranging from 0.091 to 0.371 nm/MPa and from 0.003 to 0.022 nm/°C. Analysis using the Response Surface Method (RSM) showed that pressure contributes significantly to the slope of the sensitivity, while temperature affects the offset shift of the wavelength. Overall, the research results offer a practical method for characterizing the response of FBG sensors under controlled pressure and temperature conditions.