The integration of membrane distillation with reverse electrodialysis has been investigated as a sustainable sanitation solution to provide clean water and electrical power from urine and waste heat. Reverse electrodialysis was integrated to provide the partial remixing of the concentrate (urine) and diluate (permeate) produced from the membrane distillation of urine. Broadly comparable power densities to those of a model salt solution (sodium chloride) were determined during evaluation of the individual and combined contribution of the various monovalent and multivalent inorganic and organic salt constituents in urine. Power densities were improved through raising feed-side temperature and increasing concentration in the concentrate, without observation of limiting behaviour imposed by non-ideal salt and water transport. A further unique contribution of this application is the limited volume of salt concentrate available, which demanded brine recycling to maximise energy recovery analogous to a battery, operating in a ‘state of charge’. During recycle, around 47% of the Gibbs free energy was recoverable with up to 80% of the energy extractable before the concentration difference between the two solutions was halfway towards equilibrium which implies that energy recovery can be optimised with limited effect on permeate quality. This study has provided the first successful demonstration of an integrated MD-RED system for energy recovery from a limited resource, and evidences that the recovered power is sufficient to operate a range of low current fluid pumping technologies that could help deliver off-grid sanitation and clean water recovery at single household scale.
Non-sewered sanitation is currently dependant upon pit latrine emptying, the safety of which is compromised by the high costs of faecal sludge transport to centralised treatment facilities. Transport in turn is hindered by the complex rheology of pit latrine sludge. This study therefore characterised the compressional rheology of fresh faeces and modelled the implications for passive (gravity) or mechanical (forced) solid/liquid separation. This informs on the viability of decentralising dewatering for more efficient volume reduction and improving the economics of transportation. The gel point (ϕg) is the solids concentration where the material has a networked structure and signifies the point when mechanical intervention is required for further solid-liquid separation. For fresh faeces, ϕg ranged between 6.3 and 15.6% total solids (TS) concentration. This is significantly higher than the ϕg observed for wastewater sludge at centralised facilities, and it implies that passive gravity driven processes can suffice to improve localised dewatering. The kinetics of passive sedimentation of faecal material were modelled and illustrate thickening from 3 to 10% TS concentration in <0.5 h. This highlights that early intervention to thicken faeces while fresh can improve solid/liquid separation efficiency. Filtration of fresh faeces was characterised by lengthy cake filtration times and comparably short compression times, more similar to mineral slurries than to wastewater sludge. Consequently, fresh faeces presented improved dewatering characteristics, supporting higher final cake solids concentrations and improved dewatering kinetics. By complementing thickening with 300 kPa filtration, a 1.4 cm thick 25% TS product could be achieved in <24 h. Investigation of matrix properties highlighted that increased conductivity (e.g. exposure to urine) negatively influenced dewaterability, an effect which could be mitigated by introducing solid-liquid separation earlier. The thermodynamically favourable compressional rheology of fresh faeces has identified that focussing on localised dewatering could radically improve the economics of faecal sludge management, primarily through reducing transport costs.
1 December 2021 in Journal of Environmental Management
In order to obviate the economic issues associated with pit latrine emptying and transport such as high water additions and rheologically difficult sludge properties, the implications of prompt solid/liquid separation were investigated. This was achieved through rheological characterisation of fresh human faeces and synthetic faeces, and comparison with aged faecal sludges. Shear yield stress, thixotropy and post-shear structural recovery were characterised for a total solids (TS) concentration range of 5–35% total solids (TS) and stickiness yield stress was determined for concentrations up to 100% TS. Fresh faeces rheology proved to be favourable when compared to aged matrices, evidenced by a lower shear yield stress and higher gel point solids concentration, suggesting that aging could alter the physico-chemical properties of faecal sludge. Fresh and synthetic faeces exhibited similar shear thinning, thixotropic behaviour with the majority of structural breakdown occurring at a low shear rate of 10 s−1, and the extent increasing with higher solids concentrations. At 32% TS, fresh faeces shear yield stress was permanently reduced by 80%, suggesting that low shear pumping could reduce the energy demand required for faeces transport. The sticky phase, which represents the region to avoid faecal transport and mechanical drying processes, was identified to range from 30 to 50% TS, with 25% TS as ideal to commence dewatering processes. This also coincides with the average solids concentration of faeces, which is achievable by source separation. This study has identified that handling of fresh faeces as opposed to aged faecal sludges would result in economic and environmental benefits, with energy, water and labour savings.
15 September 2016 in Environmental Science: Water Research & Technology
To ensure adequate access to sanitation in developing economies, off-grid single household sanitation has been proposed which obviates the need for significant infrastructure capital investment. Whilst treatment at this scale is most efficient when coupled to source separation (i.e. urine from faeces), existing source separation solutions have proved difficult to implement in this context. In this study, screw extrusion is therefore investigated to provide ‘post-flush’ source separation. Both screw characteristics and operational boundary conditions were evaluated. Preferential screw characteristics included tapering of the shaft and progressive pitch reduction, linked to a small extrusion aperture, the combination of which enhanced solids extrusion efficiency and promoted higher solids concentration in the extruded fraction. Whilst maximum extrusion efficiency was observed at high rotational speeds (over 400 rpm), this also promoted free water transport. Operating below 300 rpm instead introduced selectivity for transport of faecal sludge over urine, enabling phase separation. Constraining the volumetric ratio of urine to faeces also enhanced the extrusion rate of faecal sludge by increasing feed viscosity sufficient to overcome backpressure imposed by unmasticated food particles that would otherwise restrict separation. Importantly, this study demonstrates the feasibility of screw extrusion for ‘post flush’ separation of urine and faeces which constitutes a significant advancement towards realising sanitation at a single household scale.
19 August 2024 in Environmental Science: Water Research & Technology
Thermally driven membrane processes provide an alternative method to conventional pressure driven processes to recover high quality water and manage odour from concentrated blackwater, using a low-grade heat source instead of electrical energy.