This paper presents the design of a wake-up receiver (WuRX) that both improves sensitivity and reduces power over prior art through a multi-faceted design featuring an off-chip impedance transformation network with large passive voltage gain, an active envelope detector with high input impedance to facilitate large passive voltage gain, a low-power precision comparator, and a low-leakage digital baseband correlator. Implemented in a 180-nm silicon on insulator CMOS process using dynamic threshold-voltage MOSFET (DTMOS) devices, the OOK-modulated WuRX operates at 113.5 MHz and achieves a sensitivity of -69 dBm, while consuming just 4.5 nW from a 0.4-V supply.
5 September 2018 in IEEE Journal of Solid-State Circuits
This paper presents the analysis and design of a relaxation oscillator that counteracts the complementary-toabsolute-temperature (CTAT) property of the comparator delay with the proportional-to-absolute-temperature (PTAT) property of the RC core to realize temperature-stabilized operation. By using a feedback bias network to linearize the comparator CTAT delay, thus improving the overall temperature stability by 20x, this technique enables a comparator with ~20x less bandwidth and an overall oscillator with ~5x lower power than conventional approaches. In a 0.18-μm silicon on insulator CMOS process, this design consumes 1.14 nW from a 0.4-V supply operating at 1.22 kHz, with a temperature coefficient (TC) as low as 40 ppm/°C (μ = 94 ppm/°C for n = 5) achieving stateof-the-art efficiency (0.93 nW/kHz) for kilohertz-range relaxation oscillators.
12 October 2018 in IEEE Solid-State Circuits Letters
A wake-up receiver (WuRX) that achieves –80.5 dBm sensitivity with only 6.1 nW of power is presented. High sensitivity is achieved via a passive pseudo-balun envelope detector (ED) with a high input impedance (>750 kΩ || <1.4 pF) that enables a 30.6 dB passive voltage gain transformer while providing differential output and improving the conversion gain by 2× compared to a conventional single-ended input passive ED for a given input capacitance. The WuRX is implemented in a 180 nm CMOS process and operates from a 0.4 V supply.
4 November 2019 in IEEE Journal of Solid-State Circuits
This article presents a miniaturized wake-up receiver (WuRX) that is temperature-compensated yet still consumes only 22.3 nW (7.3 nW excluding the temperature-compensation blocks) while operating at 9 GHz (X-band). By moving the carrier frequency to 9 GHz and designing a high impedance, passive envelope detector (ED), the transformer size is reduced to 0.02 cm² while still achieving 13.5 dB of passive RF voltage gain. To further reduce the area, a global common-mode feedback (CMFB) technique is utilized across the ED and baseband (BB) amplifier that eliminates the need for off-chip ac -coupling components. Multiple temperature-compensation techniques are proposed to maintain constant bandwidth of the signal path and constant clock frequency. The WuRX was implemented in 65- (RF) and 180-nm (BB) CMOS and achieves -69.5- and -64-dBm sensitivity with and without an antenna, respectively. Importantly, the sensitivity is demonstrated to vary by only 3 dB from -10 to 40 °C. This article demonstrates state-of-the-art performance for WuRXs operating at >1 GHz while achieving the smallest area and best temperature insensitivity.
18 October 2022 in IEEE Open Journal of the Solid-State Circuits Society
Wake-up receivers (WuRXs) offer a potentially energy-efficient means to enable asynchronous wake-up of higher-power and higher-performance radios without needing frequent (often energy-expensive) synchronization. Since WuRXs are typically on for a large percentage of the time, keeping their power consumption very low is critical to minimizing total energy draw. However, this is difficult while maintaining good sensitivity, interference resiliency, and robustness, all with application-appropriate wake-up latencies and form factors. This article reviews the main challenges facing WuRXs, outlines the most popular WuRX architectures, and details essential design techniques and trade-offs towards enabling utility in emerging applications.
A 402-405 MHz MICS-band wake-up receiver is presented that achieves -63.8 dBm sensitivity at 4.5 nW. High sensitivity at 400 MHz is accomplished via an 18.5 dB passive voltage gain transformer filter loaded by a high input impedance (R in > 30 kΩ), high scaling factor (k ED > 300), 1.8 nW current re-use pseudo-balun envelope detector, while low power is achieved by operating all active circuits, including the re-generative comparator, baseband correlator, and temperature compensated relaxation oscillator in sub-threshold with a single 0.4 V supply. The chip is fabricated using 0.18 μm CMOS SOI process and achieves the highest figure of merit of all direct envelope detection-based wake-up receivers operating above 400 MHz.