Finite commutation times are associated with the concurrent occurrence of both voltage-across and current-through semiconductor switches, leading to switching power losses. To alleviate them, soft-switching techniques have been developed. Soft-switching converters can be classified into quasi-resonant and multiresonant, resonant-transition, and resonant power converters (RPCs). This article focuses on RPCs, due to their high power density and efficiency. Specifically, RPC topologies with multiple elements are described, and their input-output relationships and efficiency are illustrated. The merits and limitations of RPCs are discussed and compared. An RPC intended to charge the battery of an electric vehicle (EV) is presented, and experimental results are discussed.
18 March 2024 in IEEE Open Journal of Power Electronics
The main factor that drives the aging of power semiconductor modules is the thermally induced stress caused by the maximum temperature and temperature swings. This thermally induced stress is usually counteracted in passive designs with oversizing of components, which brings additional cost to the system. This is a major limitation of future power electronic systems that are required to be more reliable with reasonable cost and for many applications to be lighter and smaller. Active thermal control (ATC) is a possibility to reduce the thermal stress of components during real-time operation without the need to modify the expensive converter power stage. Many studies have shown the potential of ATC to not only extend the lifetime of power converters because of the reduced stress, but also to increase the converter devices utilization by pushing them into their thermal limits with proper control. This makes ATC an appealing way to realize the contradicting reliability, cost, and power density requirements. This paper provides an overview of the benefits and objectives, structure, and implementation possibilities of ATC. It also provides and overview of the limitations and disadvantages of many ATC strategies. Based on this discussion, it highlights key issues that must be addressed by future research. Among them is minimizing the impact of different ATC strategies on the power losses, operational cost, and output voltage and current quality.
10 February 2009 in International Journal of Energy Research
The paper is concerned with the soft-switching capabilities of the Single Active Bridge (SAB) converter. At first, soft-switching of the double active bridge converter is reviewed. Then, operation of the SAB converter is investigated with the end of assessing its soft-switching capabilities in both the discontinuous and continuous conduction mode. It is found that the SAB converter experiences either full or incomplete soft-switching depending on the working conditions. Afterwards, the procedure to size the capacitors for implementing soft-switching is illustrated. At last, an under-development power supply equipment exploiting the theoretical findings of the paper is presented together with a preliminary design of its components.
In general, analysis of Resonant Power Converters (RPCs) is more complex than conventional converters. Consequently, it is common to adopt methods that facilitate the analysis. One of them is the First Harmonic Approximation (FHA). It assumes that only the fundamental harmonic of the current/voltage quantities affects the RPC operation, thanks to the filtering action of the resonant tank network (RTN) embedded in RPCs. The RPC stages can then be represented by simple equivalent circuits with sinusoidal solicitations and the operation can be studied by the standard linear ac analysis. In this paper the characteristics of RPCs with RTN made of two, three, and four elements are investigated using the FHA method. Input impedance, voltage gain and efficiency are derived and discussed for the various topologies. Merits and limitations of the topologies are also addressed.