Yang Zhang

Yang Zhang

Auto-generated profile, based on publicly available information

Yang Zhang

IMEC, Leuven, Belgium

Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 June 2021 in IEEE Transactions on Microwave Theory and Techniques
Verified
Journal Article
Closed access
XTXinyan Tang
Xinyan Tang
YLYao Liu
Yao Liu
GMGiovanni Mangraviti
Giovanni Mangraviti
ZZZhiwei Zong
Zhiwei Zong
KKKhaled Khalaf
Khaled Khalaf
PWPiet Wambacq
Piet Wambacq
This article presents practical design considerations and methodologies for a 28-GHz front-end module (FEM) in 22-nm fully depleted silicon on insulator (FD-SOI) CMOS technology for the fifth generation (5G) wireless communication. The design adopts a gain-boosting technique that is comprehensively analyzed with a transformer-based stacked-FET power amplifier (PA). Then, the co-design of the transmit/receive (T/R) switch with the PA and low-noise amplifier (LNA) is investigated, and an electrostatic-discharge (ESD)-aware T/R switch incorporating PA circuitry is proposed to leverage the Tx- and Rx-mode performance. Moreover, the robustness of standalone PA and Tx-mode FEM is simulated and experimentally verified. Furthermore, the ground return paths and supply parasitic paths of the adopted single-ended LNA together with the proposed T/R switch are studied, properly simulated, and assessed. Finally, the proposed PA topology is first verified standalone, exhibiting 32-dB power gain ( $G_{p}$ ), an 18.2-dBm output 1-dB compression point (OP 1 dB ), and a 31.1% power-added efficiency (PAE) at OP 1 dB (PAE 1 dB ). Using this PA in the FEM yields a Tx-mode OP 1 dB /PAE 1 dB of 16 dBm/19.4%, and an average output power (Pout avg )/PAE of 10.1 dBm/8.3% for a 100-MHz bandwidth 256-QAM single-carrier signal at an error-vector magnitude (EVM) of −30 dB. In the Rx mode, noise figure (NF) and input-referred third-order intercept point (IIP3) are 3.2 and −5.4 dBm, respectively. A 2-kV human-body model (HBM) ESD protection of the FEM is predicted in transient simulations and measured with transmission line pulse (TLP) tests.

30 August 2021 in IEEE Journal of Solid-State Circuits
Verified
Journal Article
Closed access
YZYang Zhang
Yang Zhang
GMGiovanni Mangraviti
Giovanni Mangraviti
JNJohan Nguyen
Johan Nguyen
ZZZhiwei Zong
Zhiwei Zong
KKKamil Kapusuz
Kamil Kapusuz
PWPiet Wambacq
Piet Wambacq
Active load impedance variations in a phased array transmitter cause significant power amplifier (PA) performance degradation, in terms of output power, linearity, and power-added efficiency, which are key parameters to enable high-speed data throughputs using spectrally efficient modulation schemes. The system performance can be restored by using PAs having active or passive reconfigurability with the help of antenna impedance sensors. This article presents a low-power reflection-coefficient sensor for 5G millimeter-wave phased-array applications. The complex load impedance of the PA is determined based on the complex voltage over a sensing element, which can be integrated and co-designed with the PA output matching network, with minimal loss (< 0.2 dB) and a negligible area penalty. A full-range phase detector with improved detection resolution is proposed, enabling an amplitude-insensitive phase detection. Fabricated in a 22 nm FD-SOI process, the sensor prototype occupies a silicon area of 0.024 mm 2 and consumes 13.2 mW power. The sensor demonstrates a wide detection range with $\vert \Gamma \vert $ up to 0.7 (VSWR 5.67) in a load-pull test at 28 GHz. From $\Gamma $ circle of 0.2 up to 0.7, the maximum detection errors in the magnitude and phase of the $\Gamma $ are 0.14° and 40°, respectively.

6 October 2025 in IEEE Transactions on Microwave Theory and Techniques
Verified
Journal Article
Closed access
YZYang Zhang
Yang Zhang
KVKristof Vaesen
Kristof Vaesen
GMGiovanni Mangraviti
Giovanni Mangraviti
KKKamil Kapusuz
Kamil Kapusuz
SPSehoon Park
Sehoon Park
GGGiuseppe Gramegna
Giuseppe Gramegna
This article presents a 4-way transmitter (TX) array suitable for beamforming operation at D-band. The transmitter is implemented using zero-IF architecture with LO beamforming. The signal path comprises an I/Q baseband (BB) section, direct up-conversion, and a power amplifier chain, supporting a wideband operation from 118 to 147 GHz. A 5-stage 2-way power amplifier chain provides a saturation output power up to 11 dBm. The probing measurement results demonstrate up to 64 quadrature amplitude modulation (64QAM) [30 Gb/s at −25 dB rms-error vector magnitude (EVM)] and achieve a data rate of 56 Gb/s with a −17 dB rms-EVM at an output power of 3 dBm using 16QAM modulation. The LO chain contains a 14–16 GHz buffer, a cascade of two frequency triplers for LO generation at D-band using an external LO reference. A tunable matching network with 6-bit capacitor-band control is implemented in the buffer stage together with a polarity switch to achieve full range phase control. An efficient I/Q generation scheme is implemented by exploiting the last tripler before the I/Q mixer: two LC buffers after 1st tripler generates ±15° phase offset. This results into ±45° phase offset after the 2nd tripler. The benefits of our sub-harmonic I/Q generation are: 1) no I/Q hybrid operating in D-Band is needed; 2) the limited ±15° phase offset required allows an easy LC tuned buffer implementation with limited amplitude variation across phase range; and 3) this amplitude variation is removed by 2nd tripler and LO buffers that operate at saturation level. This LO beamforming scheme ensures a phase resolution of 0.1° in measurement. A single TX channel draws 232 mW from a 0.8 V supply and has an area of $1.17\times 0.3$ mm2 in a 22 nm fully depleted silicon on insulator (FD-SOI) process. The 4-way beamformer IC has been flip-chip mounted on a low-cost 10-layer printed circuit board (PCB) and connected to a planar antenna array integrated at the backside of the PCB. The antennas are placed with 1.1 mm spacing and each antenna contains 4 aperture-coupled patch units to enhance the radiation pattern. The 4-way TX beamformer has been tested over-the-air (OTA) with a reference receiver achieving 24 Gb/s with −25 dB rms-EVM at 0.4 m distance using 5G NR waveforms.

1 August 2024 in IEEE Transactions on Microwave Theory and Techniques
Verified
Journal Article
Closed access
DXDongping Xiao
Dongping Xiao
Dominique SchreursDominique Schreurs
Dominique Schreurs
RERana ElKashlan
Rana ElKashlan
YZYang Zhang
Yang Zhang
ACAdam Cooman
Adam Cooman
NCNadine Collaert
Nadine Collaert
Gate current is known to limit device performance, yet a detailed analysis of its impact on RF power performance has not been extensively documented. This article examines the influence of gate current on RF power performance. A small-signal equivalent-circuit analysis shows that gate current degrades the device’s RF power performance, with higher gate currents causing greater degradation. In addition, the effect of gate current varies with frequency due to the frequency-dependent impedance of $C_{\text{gs}}$ and $C_{\text{gd}}$ , resulting in more significant degradation at lower frequencies because of the parallel connection of gate conduction with these capacitors. These findings are validated under large-signal conditions using an experimentally verified device model for InAlN/GaN high-electron-mobility transistors (HEMTs).

12 January 2026 in IEEE Transactions on Microwave Theory and Techniques
Verified
Journal Article
Closed access
SPSehoon Park
Sehoon Park
AHArno Hemelhof
Arno Hemelhof
YZYang Zhang
Yang Zhang
GGGiuseppe Gramegna
Giuseppe Gramegna
PWPiet Wambacq
Piet Wambacq
Broadband and high-efficiency D-band frequency doubler and quadrupler chains in 250-nm indium phosphide (InP) double heterojunction bipolar transistor (DHBT) are presented, together with a design methodology that provides insights into the optimal tradeoff among conversion gain (CG), dc-RF efficiency, and the number of required buffers in the multiplier chain to achieve targeted input and output power levels. Additionally, a frequency doubler is proposed where the optimal load is defined by controlling the input common-mode impedance, allowing the load impedance to approach the matching point without sacrificing output power or efficiency. By relocating matching-related loss from the output matching network to the input common-mode path, the proposed topology enables buffer-less cascading and significantly reduces matching loss. The same technique is extended to a frequency quadrupler chain, enabling a fully buffer-less connection between cascaded impedance-adjusted frequency doublers. Thanks to the proposed doublers, the presented doubler/quadrupler exhibits a measured maximum dc-RF efficiency of 56.5%/29.7%, a peak output power of 8.9/7.4 dBm, and a peak CG of −0.1/−0.5 dB in a compact footprint of 0.24/0.37 mm2.

11 September 2023
Verified
Conference Paper
Closed access
DYDongyang Yan
Dongyang Yan
SPSehoon Park
Sehoon Park
YZYang Zhang
Yang Zhang
MIMark Ingels
Mark Ingels
PWPiet Wambacq
Piet Wambacq
A K-band transceiver (TRX) front-end in 0.15$\mu$mGaN with TRX switch functionality is presented. In a compact area of 3m$\mathrm{m}^{2}$, the chip contains a PA and LNA while also realizing a transmit/receive (T/R) switch functionality by the aid of an asymmetric edge coupler, without having an explicit switch in the TRX signal path. In TX mode, the front-end achieves a saturated output power ($\mathrm{P}_{\mathrm{s}\mathrm{a}\mathrm{t}}$) of 27. 7dBm with a 26.8% saturated PAE under a continuous wave (CW) input signal. The RX path achieves a 4. 7dB noise figure (NF). The compact MMIC can be used in phased array transceivers.