Because of the simplicity of design and measurement, as well as the accuracy of results, the 2×-thru de-embedding has replaced the traditional de-embedding algorithms such as thru-reflect-line and short-open-load-thru for printed circuit board (PCB) characterization. In this paper, the theory of $2^{n}$ -port 2×-Thru de-embedding is derived first. The self-error reduction schemes are introduced to mitigate the de-embedding errors due to non-ideal manufacturing effects that make mode conversion terms non-zero. Both the theory and the self-error reduction schemes are fully validated through simulation and measurement cases.
In this paper, systematic characterization of the dual probe, which is designed for the near field simultaneous measurement of both electric and magnetic field, is investigated rgb0,0,0with a microstrip line as the device under test (DUT). The characterization includes frequency response, transmission performance, symmetry, reflection, the intrusion of probe to the DUT, isolation of electric and magnetic field responses, field profile and spatial resolution, and differential electric field suppression. The dual probes with different design are adopted to demonstrate the systematic characterization.
Compared to 4-port de-embedding, 8-port de-embedding is much more challenging due to the presence of crosstalk terms in both the differential mode and the common mode. Using the 2 nd order mixed-mode concept, this work proposes an 8-port smart fixture de-embedding (SFD) method. The proposed method neglects modal conversion terms by requiring balanced and symmetrical designs. Analysis showed that this approximation generally has negligible impact on the de-embedded differential results with careful test fixture design.
In this paper, several methods are outlined for detecting functional changes in an IC due to external interference such as ESD or EMI. The goal is to provide diagnostic tools for detection of potential soft failure susceptibilities of complex systems during the hardware design stage without the aid of any complex software.
12 October 2022 in IEEE Transactions on Signal and Power Integrity
The difference in the dielectric permittivity of the different dielectric layers (including air) surrounding the microstrip is one of the major contributors to the far-end crosstalk (FEXT) in microstrip lines. The dielectric of the microstrip in printed circuit boards (PCBs) fabrication usually consists of two layers: the solder mask layer and the substrate layer. The characterization of the relative permittivity ( $\varepsilon_{r}$ ), dielectric dissipation factor (tanδ) for the dielectric layers of the microstrip are important parameters for board-level electronic system designs. In addition, the foil surface roughness cannot be ignored for the conductor loss modeling. In this work, an extraction method with high accuracy is proposed to characterize the dielectric material and foil surface roughness properties from the measured S-parameters with known cross-sectional geometry up to 20GHz. With the extracted properties, the FEXT and insertion loss of the microstrip can be estimated more accurately, providing design guidelines for PCB design and the material selection of the microstrip.
7 August 2019 in IEEE Transactions on Electromagnetic Compatibility
Electrostatic discharge (ESD)-induced soft failures are a critical issue for electronic systems as the failures are mostly found after the hardware design is completed. Any changes applied to the hardware may delay the project. Diagnostic tools capable of identifying soft failure-induced malfunctions in an early stage of product design help to reduce the risk of late stage ESD-induced project delays. In many cases, soft failures can be directly observed by the user interface, system crash, or other obvious indicators. However, in an early product design stage the operation system may be marginal and applications may not be available. To improve the ability to detect soft failure critical design choices, this paper presents several methods to identify ESD-induced changes which may not be observable via direct observation. These methods include the observation of ac or dc currents, monitoring dc voltages, capturing near fields and processing them via short-term fast fourier transform (FFT), wavelet transformation, down mixing to audible range, and monitoring for latch-up via thermal imaging. The paper introduces the basis of each method, shows examples, and compares them for their detection ability.