Amorphous indium gallium zinc oxide (a-IGZO) thin film transistors (TFTs) with high mobility are highly desirable to achieve high-speed operation in active-matrix displays and largearea sensors. Only a few works provided potential solutions. In this work, we have embedded carbon nanotubes (CNTs) into sputtered a-IGZO film to form a-IGZO/CNT/a-IGZO (ACA) sandwiched channel. In the ACA channel, the CNT percolation networks connected by the a-IGZO film work as high-speed carrier paths to enable faster transport of carriers during the on state while it does not degrade the leakage performance during the off state. The type and the embedding location of the CNT percolation network are critical to determine the ACA device performance, which is analyzed and verified by experiment and simulation. The optimum ACA design has approximately doubled the mobility and the on current density of the TFT. The design owns relatively better uniformity and provides a high-speed TFT solution for the advanced electronics.
30 September 2019 in IEEE Transactions on Nanotechnology
Well-aligned Carbon nanotube (CNT) arrays are expected by flexible and stretchable devices. In this paper, an asymmetric Langmuir-Blodgett (LB) method and inorganic hydrophilization method have been proposed, with which well-aligned CNT arrays on soft substrates like polyethylene naphthalate, polyimide and polydimethylsiloxane have been realized. After depositing 50 nm SiO2 for hydrophilization, the water contact angle has been significantly reduced for different substrates. The surface roughness and flexibility have also been characterized to analyze their effect on device performance. The nanotube density in the arrays can be controlled to 10-25 tubes/μm $^2$ , 25-35 tubes/μm $^2$ or 35-45 tubes/μm $^2$ by tuning the surface pressure during the LB process. With aligned semiconducting CNT arrays as channel and anisotropic metallic CNT network as gate/source/drain electrodes, a kind of all-carbon transistor on PI substrate has been fabricated for demonstration. The fabricated device shows an on/off ratio 4.51×10 $^2$ , a subthreshold swing of 92.9 mV/dec, and a carrier mobility of 15.32 cm $^2$ /Vs. More importantly, with 50 nm thick gate dielectric, the changes of threshold voltage, and carrier mobility are within 16.62% and 28.78%, respectively, even after bending 1000 times under a curvature radius of 3.66 mm.
To meet the requirements of flexible and wearable electronic devices, strain sensors with high sensitivity, stretchability and reliability are essential prerequisite. In this work, we developed a strain sensor of resistance type, which is composed of standing multi-walled carbon nanotube (MWCNT) network, reinforced by PDMS film. Benefiting from the standing MWCNT network structure, the strain sensors show high-sensitivity not only in high strain but also in the low strain region (<; 10%). In addition, the designed sensor can overcome the nonlinearity defect. The performance of the proposed strain sensors can be controlled by varying the length and density of the as-grown carbon nanotube (CNT) samples. By adjusting the CNT samples, a gauge factor up to 4.5 was achieved. Besides, the strain sensors also show high stretchability, with strain up to 120%. Finally, we utilized the sensors to detect the motions of human fingers, demonstrating their high performance in applications.