31 October 2025 in Superconductivity
25 November 2025 in Superconductivity
22 January 2024 in IEEE Transactions on Applied Superconductivity
A 20 T all REBCO conduction-cooled user magnet project is underway by Institute of Plasma Physics, Chinese Academy of Sciences (ASIPP). The REBCO magnet with no-insulation (NI) winding technique has the inner and outer winding diameters of 30 mm and 103.98 mm, respectively, and the diameter of the cold-bore is 22 mm. It consists of a stack of 10 double pancake (DP) coils wound with two different width REBCO tapes, the width of REBCO tape used for the two end double pancake is 6 mm, and the remaining DP coils is 4 mm. The operating current of the magnet is 224 A at 10 K. The inductance, maximum hoop stress and deflection angle between the conductor and z-axis are 1.57 H, 583 MPa and 1.41°, respectively. The magnetic field distortion and local stress concentration caused by screening current have been carefully considered. In addition, the electromagnetic design and parameter optimization, mechanical analysis, construction and preliminary test results of DP coils are specially discussed in this article.
22 August 2018 in IEEE Transactions on Plasma Science
According to the Chinese fusion engineering testing reactor (CFETR) central solenoid model coil (CSMC) properties test requirements, a large cryogenic test platform will be built. The feeder, as one of the important components of the platform, should be studied to afford the much valued help for the basic test facilities. This paper focuses on the feeder structural design and the stress analysis in conditions of different loads. All of the work could not only provide necessary help for building CFETR CSMC test platform but also provide the important service experience of the large cryogenic test platform in the future.
17 April 2024 in IEEE Transactions on Applied Superconductivity
The Central Solenoid Model Coil (CSMC) has been manufactured as part of the R&D projects for the China Fusion Engineering Test Reactor (CFETR), and it will undergo testing in the second half of 2024. For the safety operation of magnet, predictive analyses are required to study thermal-hydraulic behavior of the CSMC during the quench. In this paper, the different quench initial position is detailed studied, for example, quench initiates at the peak magnetic field region and the lowest magnetic field region. In addition, the different quench disturbances are considered, such as (disturber length 0.01 m and disturber time 3 ms), (disturber length 1 m and disturber time 3 ms), and (disturber length 6 m and disturber time 100 ms). In all cases, the designed quench protection system is satisfied with the present design criteria concerning the hot spot temperature and the maximum helium pressure.
14 June 2021 in IEEE Transactions on Applied Superconductivity
The High-temperature Superconducting (HTS) magnet is one of the most promising technologies to accommodate various high field applications. With the high magnetic field, the quench problem of HTS material should be considered with extra care, and the specific quench protection scheme should be projected. In this article, the modeling of the quench protection of an HTS magnet for the MRI system is presented. The modeling strategy was composed of two stages: Stage 1 the HTS magnet was in the normal operation circuit, and Stage 2 the HTS magnet was switched to the heat dissipation circuit. The 1st stage was based on the finite element method (FEM) using the H formulation together with the thermal-coupled model, which simulated the current distribution of typical HTS tapes and showed the process of temperature increase when the hot source occurred. The 2nd stage was based on the analytical model to investigate the reasonable damping resistance and the hot spot temperature of the HTS magnet.