1 December 2022 in IEEE Transactions on Instrumentation and Measurement
This paper provides parameter optimization processes of sinusoidal signal generators (SSGs) based on a digital-to-analog converter (DAC) for electrical impedance spectroscopy (EIS) applications. The SSG, which is the most power-hungry building block in EIS systems, generates a sinusoidal signal by using a DAC. To achieve high accuracy for the overall EIS system, high linearity is required for the sinusoidal signal. Thus, the SSG’s DAC is typically operated with a high oversampling ratio (OSR) and a large number of quantization levels ( LDAC ) at the expense of increased power consumption, large area, and high complexity. For efficient use of the power and area in the SSG, it is necessary to optimize the OSR, LDAC , and the order of the low-pass filter ( NLPF ). In this paper, optimal design parameters of SSGs, which can achieve highly accurate EIS systems with low complexity, are presented. First, the minimum OSR and NLPF for lowering the magnitude error to less than 0.1% are presented. Then, optimal quantization levels of finite-resolution DACs are found for sufficient accuracy and harmonic tones. In addition, the accuracy and harmonics of odd-number OSR cases are analyzed and compared with even-number OSR cases. According to the results, it is possible to design an SSG that only differs from the ideal sinusoidal signal by approximately 0.1% by using OSR ≤ 32, NLPF ≤ 2, and LDAC ≤ 256.
9 January 2025 in IEEE Transactions on Biomedical Circuits and Systems
This paper presents a new potentiostat circuit architecture for interfaces with amperometric electrochemical biosensors. The proposed architecture, which is based on a digital low-dropout regulator (DLDO) structure, successfully eliminates the need for transimpedance amplifier (TIA), control amplifier, and other passive elements unlike other typical potentiostat topologies. It can regulate the required electrode voltages and measure the sensor currents ( ISENSE ) at the same time by using a simple implementation with clocked comparators, digital loop filters, and current-steering DACs. Three different configurations of the proposed potentiostat are discussed including single-side regulated (SSR) potentiostat, dual-side regulated (DSR) potentiostat, and differential sensing DSR potentiostat with a background working electrode. These proposed potentiostats were designed and fabricated in a 180 nm CMOS process, occupying an active silicon areas of 0.0645 mm 2 , 0.1653 mm 2 , and 0.266 mm 2 , respectively. Validation results demonstrate that the proposed potentiostats operate on a wide sampling frequency range from 100 Hz to 100 MHz and supply voltage range from 1 V to 1.8 V. The proposed DSR potentiostat achieves a minimal power consumption of 3.7 nW over the entire dynamic range of 129.5 dB.