Rishabh Raj

Rishabh Raj

Auto-generated profile, based on publicly available information

Rishabh Raj

Electromechanical System Team, Volvo Cars Corporation in Gothenburg, Gteborg, Sweden

Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
26 July 2021 in IEEE Transactions on Instrumentation and Measurement
Verified
Journal Article
Closed access
RRRishabh Raj
Rishabh Raj
BRBoggavarapu Sai Ram
Boggavarapu Sai Ram
RBRahul Bhat
Rahul Bhat
GUGreeshma Mohan Unniachanparambil
Greeshma Mohan Unniachanparambil
SKShrikrishna V. Kulkarni
Shrikrishna V. Kulkarni
Energy losses during the magnetization process of soft magnetic laminations depend on the excitation waveform. Manufacturers of magnetic materials may not provide losses for different excitation waveforms. This may affect the accuracy of the predicted losses which are used to estimate the performance of electrical equipment during the predesign stage. Thus, a characterization tool which is capable of measuring hysteresis loops under controlled magnetization is required. Digital characterization systems available in literature use expensive commercial power amplifiers. In this work, a cost-effective power amplifier circuit is developed and interfaced with a LabVIEW program to characterize soft magnetic materials. The measurements for a sinusoidal excitation from the proposed setup are validated with those from a standard commercial measuring setup. The system is also used to measure hysteresis loops for arbitrary magnetization conditions (magnetic flux density ( B) with harmonics). The proposed setup can operate over a frequency range 35-500 Hz. A small Epstein frame is also designed for measurements at higher frequencies (>200 and <; 500 Hz). A provision is also made to predict three components of dynamic hysteresis losses at any frequency in the above range using the loss separation approach. This capability of the setup enables the user to predict the losses at frequencies beyond the capability of the tool. The predicted losses using this algorithm are validated with measured losses. The proposed setup is cost-effective and can be developed easily using basic electronic components.

14 April 2025 in IEEE Transactions on Energy Conversion
Verified
Journal Article
Closed access
RRRishabh Raj
Rishabh Raj
TLTim Lindberg
Tim Lindberg
ZLZijie Lin
Zijie Lin
DSDeepak Singh
Deepak Singh
KBKim Bergsro
Kim Bergsro
TTTorbjörn Thiringer
Torbjörn Thiringer
High performance rotating electric machines are a necessity in the automotive sector. The characteristics of electric steel materials given in the datasheet used in electric machines do not account for the effect of stress due to the manufacturing process. It is possible to account for the effect of stress coming more precisely from stator housings after press and shrink fitting which degrades the loss properties of electrical steel. A process is developed, which includes the development of a test bench for characterizing the magnetic properties of electric steel when put under compressive stress. The proposed hardware setup is a novel test bench capable of achieving high compressive stress up to 60 MPa and for a maximum of 1 kHz fundamental frequency. A modified compressive stress dependent loss model for analyzing impact on the total power loss is proposed. Further, a coupled multiphysics finite element analysis including structural and magnetic analysis to evaluate the machine performance over the entire operating range and vehicle performance over relevant drive cycles for passenger electric vehicles. A 7% increase in total machine losses was found at an average in a WLTC class-3 drive cycle due to shrink and press fitting of the stator housing.