This paper presents a 7-parameter analytical model of the MOS transistor based on the inversion charge targeted at the development of simplified analytical circuit design methodologies that take into account the physics of the MOS transistor. The proposed design-oriented model allows for the first time to describe both the main short-channel effects of advanced nanometric technologies and the dependence of the transistor drain current on the drain voltage, while the model remains valid for all bias regimes (from weak to strong inversion) and for all operating regions (linear and saturated). A simple procedure based on the device physics is proposed to estimate the transistor model parameters for a given technology. Furthermore, analytical expressions of the current derivatives are developed targeting different design scenarios. The accuracy of the proposed model is validated by direct comparison to silicon measurements of N-MOS transistors in 28 nm FD-SOI technology for channel width of 1 μm and channel lengths of 30 nm, 60 nm and 150 nm, and also to simulations performed with an industry-standard compact model.
18 June 2019 in IEEE Transactions on Circuits and Systems I: Regular Papers
This paper presents a feedback receiver for the digital predistortion (DPD) of radio frequency (RF) power amplifiers (PAs). In contrast to conventional architectures, the receiver samples in the frequency domain. By randomly selecting a frequency bin in each sampling interval, the PA model is identified with substantially lower acquisition bandwidth and sampling rate. The receiver prototype is implemented in a 28-nm FD-SOI technology and samples at 4MS/s instead of the full Nyquist rate of 168MS/s for a 20-MHz Long Term Evolution (LTE) signal with spectral regrowth. The prototype is shown to linearize a 4-W small base station power amplifier from an adjacent channel leakage ratio (ACLR) of -35 dBc to -47.7 dBc, after processing only about 250 samples.
1 March 2019 in IEEE Transactions on Microwave Theory and Techniques
This paper presents a widely tunable digital delay element suitable for low-power low-frequency continuous-time digital signal processing systems. The design uses features of the 28 nm FD-SOI CMOS technology to precisely control currents in the pA range and significantly reduce leakage power. The measured tuning range is significantly larger than prior art covering more than 3 decades from 30 ns to 100 μs making it suitable for CT-DSP low frequency filters. At 0.7 V supply voltage, the dynamic power consumption is 15 fJ/event with a residual power consumption due to leakage of 14 pW.
18 April 2023 in IEEE Transactions on Circuits and Systems II: Express Briefs
This paper proposes an innovative concept of spatial third-order intermodulation products (IMD3) filtering in millimeter-wave 5G phased arrays. This technique aims to relax the linearity constraints on the power amplifiers (PA) and thus power consumption. Implementation of independent control of the phase of IMD3 is proposed by using the nonlinear output capacitance of metal-oxide semi-conductors (MOS) amplifiers under phase-controlled second harmonic injection. The implemented control uses beamforming properties to perform spatial filtering of IMD3 product. A second harmonic injection on a power amplifier is proposed in STMicroelectronics CMOS065SOIMMW technology at 28 GHz. It shows phase control of IMD3 with a range of 35 degrees, allowing relaxation up to 17 dB on the linearity of large phased array power amplifiers.
1 September 2026 in IEEE Transactions on Electron Devices