6 November 2023 in IEEE Transactions on Electron Devices
In this article, the X-ray radiation effects on colloidal quantum dot photodiode (QDPD)-based short-wave infrared (SWIR) complementary metal-oxide semiconductor image sensors (QD-CISs) are studied. Individual QDPD, silicon readout IC (Si-ROIC), and QD-CIS are evaluated together for a comprehensive analysis. The dark current, activation energy, and external quantum efficiency (EQE) of samples are investigated before and after irradiating with 58.2 keV of X-ray radiation, which has a different total ionizing dose (TID) range from 22 to 220 krad. X-ray irradiation on Si-ROIC induces mid-band gap trap states and increases the dark current according to the increasing TID. However, for the QDPD, despite an increase in the TID, the dark current reduces and the EQE slightly enhances at the SWIR wavelength. The QD-CIS shows a decrease in the dark current like the QDPD results, as the TID increases. The activation energy of QD-CIS rarely changes regardless of TID amounts. The X-ray radiation effect on QDPD results in enhanced performance, and this effect continues in the integrated QD-CIS, whereas the effect of Si-ROIC degradation is minor in the current experimental range. Thus, these findings provide significant insights into the utilization of QD-CIS in various X-ray applications.
1 July 2025 in Journal of Instrumentation
This article presents a new global shutter (GS) pixel design with radiation-hardened-by-design (RHBD) device modifications and correlated double sampling (CDS). Global shutter imagers present undeniable advantages by exposing all pixels simultaneously. Once in-pixel storage is included, the pixel readout can be operated simultaneously with exposure, enabling faster operation and flashed light. Additionally, this architecture is robust against motion defects and easy to operate in synchronous mode. The radiation tolerance of the outlined pixel is targeted up to 1 MGy SiO2 total ionizing dose (TID). A partially pinned photodiode (pPPD) structure, combined with an enclosed transistor layout known as a “butterfly” [1,2] is used to withstand such a high TID value. The use of the p+ implant on top of the photodiode and recessed shallow trench isolation (STI) reduce the dark current from the TID-induced interface traps and SiO2 interface while also shielding the photodiode (PD) region from TID-induced positive charges in the SiO2. CDS [3] is required to reduce the read noise by suppressing important noise sources such as photon shot noise, thermal noise (kTC) and flicker noise contributions. Two in-pixel storage capacitors and two readout paths are implemented to allow CDS. The pixel operation includes a sample phase where the pixel signal is locally stored followed by a reset phase and the pixel reset is stored. The in-pixel storage is designed with enclosed butterfly MOS devices that allow great charge density for low area and with limited leakage due to the RHBD design. The readout is performed by operating two output source followers (SF) and two output buses. The pixel is designed using 180 nm CMOS Image Sensor (CIS) technology. It achieves a pre-rad dynamic range of 60.9 dB and a shutter efficiency of 99,6%.
1 September 2026 in Journal of Instrumentation
Front-end amplification inside a pixel can reduce the contribution of downstream readout noise in complementary metal-oxide-semiconductor (CMOS) image sensors, but its practical value must be assessed together with penalties in spatial uniformity, implementation overhead, and operating complexity. This work presents a CMOS image sensor prototype incorporating an in-pixel operational transconductance amplifier (OTA) with switchable unity-gain and open-loop high-gain modes. A dedicated transfer-gate layout optimization is also implemented to reduce the floating-diffusion capacitance and improve the conversion gain. The prototype enables a same-chip comparison between the proposed OTA pixel and a reference four-transistor (4T) pixel under a common readout environment. Measurement results show that the in-pixel OTA can reduce the input-referred temporal noise (down to 0.67 e - rms ) by suppressing the contribution of subsequent readout stages, while the high-gain mode also increases pixel-to-pixel variation and spatial non-uniformity. A measured pixel conversion gain of up to 6.47 mV/ e - is achieved in the open-loop high-gain mode. The switchable-gain operation supports wide-dynamic-range readout by combining low-gain and high-gain responses. In addition to temporal-noise characterization, image lag and spatial non-uniformity are evaluated, and the results are discussed in terms of the trade-off between noise reduction, uniformity, and implementation cost. This work therefore provides a measured assessment of the practical benefits and limitations of in-pixel front-end amplification for low-noise and high-dynamic-range (HDR)-oriented CMOS image sensors.