The combustion of gaseous fuels in condensing boilers contributes to the greenhouse gas and toxic compound emissions in exhaust gases. Hydrogen, as a clean energy carrier, could play a key role in decarbonizing the residential heating sector. However, its significantly different combustion behavior compared to hydrocarbon fuels requires thorough investigation prior to implementation in heating systems. This study presents experimental and theoretical analyses of the co-combustion of natural gas with hydrogen in low-power-output condensing boilers (second and third generation), with hydrogen content of up to 50% by volume. The results show that mixtures of hydrogen and natural gas contribute to increasing heat transfer in boilers through convection and flue gas radiation. They also highlight the benefits of using the heat from the condensation of vapors in the flue gases. Other studies have observed an increase in efficiency of up to 1.6 percentage points compared to natural gas at 50% hydrogen content. Up to a 6% increase in the amount of energy recovered by water vapor condensation was also recorded, while exhaust gas losses did not change significantly. Notably, the addition of hydrogen resulted in a substantial decrease in the emission of nitrogen oxides (NOx) and carbon monoxide (CO). At 50% hydrogen content, NOx emissions decreased several-fold to 2.7 mg/m3, while CO emissions were reduced by a factor of six, reaching 9.9 mg/m3. All measured NOx values remained well below the current regulatory limit for condensing gas boilers, which is 33.5 mg/m3. These results highlight the potential of hydrogen blending as a transitional solution on the path toward cleaner residential heating systems.
This study presents the design, thermodynamic analysis, and experimental validation of a condensing economizer dedicated to bi-omass-fired heating boilers. The proposed device incorporates a centrally arranged flue-gas distribution chamber and a water-cooled tube bundle that enables recovery of both sensible heat and the latent heat released during water-vapor condensation. The economizer, protected under Patent No. PL247342B1 was evaluated through analytical modelling and laboratory testing per-formed on pellet boilers with rated outputs of 25–100 kW. The heat-transfer model, which couples convective and condensation mechanisms, demonstrated that the presence of water vapor in the flue gas significantly increases the effective heat transfer coef-ficient, thereby enhancing the overall energy recovery potential. Prototype units with heat-exchange surfaces ranging from 0.63 to 2.90 m2 achieved thermal outputs between 1.8 and 7.8 kW, with stable condensation occurring when the boiler’s return-supply temperature difference was maintained at ΔT ≥ 25 °C. Experimental results confirmed a substantial reduction in flue-gas tempera-ture (down to 59 °C at nominal load and 34 °C at reduced load), which translated into an increase in gross boiler efficiency to 107% and 119%, respectively. All emission indicators complied with the Ecodesign Directive (EU) 2015/1189, while seasonal effi-ciency analysis yielded an Energy Efficiency Index of 167.8 (A+++). The findings demonstrate that the integrated counterflow–crossflow economizer significantly improves waste-heat recovery, reduces fuel consumption, and lowers particulate and gaseous emissions. Owing to its modular construction and corrosion-resistant design, the system is suitable for practical implementation in modern biomass heating installations.
25 August 2026 in CIEPŁOWNICTWO, OGRZEWNICTWO, WENTYLACJA
W artykule przedstawiono analizę możliwości wykorzystania pomp ciepła do dekarbonizacji systemów grzewczych poprzez zastępowanie grzałek elektrycznych źródłami odnawialnymi (gazowymi i biomasowymi). Omówiono aktualne uwarunkowania transformacji energetycznej w Polsce i Unii Europejskiej, ze szczególnym uwzględnieniem wykorzystania gazu ziemnego, wodoru oraz biomasy w budownictwie indywidualnym. Dodatkowo zaprezentowano analizę techniczną biwalentnych systemów grzewczych opartych na pompach ciepła z dodatkowymi źródłami szczytowymi: kotłami elektrycznymi, gazowymi i biomasowymi (pellet drzewny). Zastosowanie biomasy w układach hybrydowych pozwala na dalsze ograniczenie emisji CO2 przy zachowaniu wysokiej efektywności energetycznej pomp ciepła. Autor prezentuje również koncepcję kotła kondensacyjnego małej mocy na biomasę, opracowywanego w ramach programu „Doktorat Wdrożeniowy”, który może wspomagać w nowoczesnych systemach niskoemisyjnych.