Among conductive polymers, PEDOT films find the widest application in electronics. For photovoltaic applications, studies of their optical properties, stability, and electrical conductivity are of greatest interest. However, the PEDOT:PSS transport layers, when used in photovoltaic cells, have a high electrical resistance, which prevents solar cells from increasing their efficiency. One of the promising ways to improve their electrical properties is the use of composite materials based on them, in which the conductivity can be increased by introducing various additives. In this work, conductive polymer films PEDOT:PSS (poly (3,4-ethylenedioxythiophene):polystyrene sulfonate acid) doped with a number of amines (Pentylamine, Octylamine, Diethylamine, Aniline with carbon nanotubes) were obtained and studied. It is shown that, depending on the concentration of dopants, the electrical conductivity of PEDOT:PSS films can be significantly improved. In this case, the light transmission of the films practically does not change. The process of improving the conductivity by treating the surface of the finished film with amines, followed by heat treatment, was studied. It is assumed that the improvement in conductivity is the result of the self-assembly of monolayers of organic molecules on the surface of the PEDOT:PSS film leading to its p-doping due to intermolecular interaction.
30 October 2022 in Electrochemistry Communications
The crystallization conditions from the solution play an important role in determining the morphology, phase composition, and photovoltaic properties of perovskite films. Post-processing of the obtained films can have a crucial role in increasing the grain size of perovskite and enhancing its crystallinity. It has been shown that the formation of crystal nuclei can be utilized to accelerate crystallization. In this case, crystallization occurs through the growth of seed crystals created in the solution, enabling the formation of relatively large crystals. For the deposition of CH3NH3PbI3 hybrid halide perovskite films from a solution of the perovskite in dimethylformamide, the spin coating technique was employed. Pre-crystallization was achieved by annealing the films at a temperature of 100 or 110 °C. The dissolution process involved adding a drop of dimethylformamide onto the substrate surface and allowing it to partially dissolve the perovskite film. Subsequently, residual solvent was removed through spin coating. The morphological analysis of the perovskite film surface after recrystallization at temperatures ranging from 80 to 130 °C was performed. The infrared transmission spectra of the obtained perovskite films were investigated, and their light absorption characteristics were studied through transmission spectra. The perovskite structure in the obtained films was confirmed by the peaks observed in the X-ray diffraction patterns. It has been shown that the photocurrent values for solar cells with perovskite films obtained by recrystallization are 15–20% higher than those of perovskite films obtained by traditional crystallization methods.
The modes of synthesis of TiO2 films with semiconducting properties by the method of electrochemical oxidation of Ti are proposed for use as an electronic transport layer of perovskite solar cells. To anodize the titanium film, the electrolyte based on a mixture of a 2 % aqueous solution of oxalic acid and a 1 % aqueous solution of sulfamic acids was used. The results obtained showed that Al and Ni have injection contacts to the anodic TiO2 films. Nanoscale titanium oxide films have low resistivity and rectilinear and symmetric I - V characteristic branches. Annealing of titanium oxide films leads to a significant decrease in the resistivity.