Smart cities employ technology and data to increase efficiencies, economic development, sustainability, and life quality for citizens in urban areas. Inevitably, clean technologies promote smart cities development including for energy, transportation and health. The smart city concept is ambitious and is being refined with standards. Standards are used to help with regulating how smart cities function and contributing to define a smart city. Smart cities must be officially recognized by national and international authorities and organizations in order to promote societal advancement. There are many research and review articles on smart cities. However, technical standards are seldom discussed in the current literature. This review firstly presents the study of smart city definitions and domain. The well-known smart city standards will be presented to better recognize the smart city concept. Well-defined standards allow meaningful comparisons among smart cities implementation. How smart city initiatives make a city smarter and improve the quality of life will be discussed for various countries. This review highlights that technical standards are important for smart cities implementation. This paper serves as a guide to the most recent developments of smart cities standards.

This paper demonstrates the use of Universal Software Radio Peripheral (USRP), together with Raspberry Pi3 B+ (RP3) as the brain (or the decision making engine), to develop a distributed wireless network in which nodes can communicate with other nodes independently and make decision autonomously. In other words, each USRP node (i.e., sensor) is embedded with separate processing units (i.e., RP3), which has not been investigated in the literature, so that each node can make independent decisions in a distributed manner. The proposed testbed in this paper is compared with the traditional distributed testbed, which has been widely used in the literature. In the traditional distributed testbed, there is a single processing unit (i.e., a personal computer) that makes decisions in a centralized manner, and each node (i.e., USRP) is connected to the processing unit via a switch. The single processing unit exchanges control messages with nodes via the switch, while the nodes exchange data packets among themselves using a wireless medium in a distributed manner. The main disadvantage of the traditional testbed is that, despite the network being distributed in nature, decisions are made in a centralized manner. Hence, the response delay of the control message exchange is always neglected. The use of such testbed is mainly due to the limited hardware and monetary cost to acquire a separate processing unit for each node. The experiment in our testbed has shown the increase of end-to-end delay and decrease of packet delivery ratio due to software and hardware delays. The observed multihop transmission is performed using device-to-device (D2D) communication, which has been enabled in 5G. Therefore, nodes can either communicate with other nodes via: (a) a direct communication with the base station at the macrocell, which helps to improve network performance; or (b) D2D that improve spectrum efficiency, whereby traffic is offloaded from macrocell to small cells. Our testbed is the first of its kind in this scale, and it uses RP3 as the distributed decision-making engine incorporated into the USRP/GNU radio platform. This work provides an insight to the development of a 5G network.