This study compares the performance of the Hollow Fiber (HF) and Flat Sheet (FS) types of membrane bioreactors (MBRs) for the treatment of food and beverage (F&B) industry wastewater in a pilot-scale study of a wastewater treatment plant (WWTP). HF and FS membrane configurations were evaluated at two different Mixed Liquor Suspended Solid (MLSS) levels: 6000 mg/L and 12,000 mg/L. The performance of each configuration was evaluated in terms of Chemical Oxygen Demand (COD) and Total Suspended Solid (TSS) removals for effluent quality measurement. The transmembrane pressure (TMP), flux rate, and silt density index (SDI) were monitored and calculated for membrane fouling assessment. The results show that the rejection rates of COD and TSS for HF and FS membrane types were more than 84% for the two different MLSS levels. During the study, the HF membrane recorded 0.3 bar transmembrane pressure, which complies with the recommended range (i.e., two to three times of chemical cleaning). On the other hand, the FS membrane operates without chemical cleaning, and the TMP value was below the recommended range at 0.2 bar. It was found that the flux values recorded for both the HF and FS systems were within the recommended range of 40 L/m2/h. Analysis of SDI revealed that the calculated index ranged between 1 and 2.38 and was within the allowable limit of 3. Both types of MBR consistently achieved an 80% to 95% rejection rate of COD and TSS. Effluent quality measurement of treated F&B wastewater in this pilot-scale study using a WWTP integrated with an MBR indicated a good achievement with compliance with the Malaysia industrial effluent discharge standards.
2 August 2024 in Environmental Science and Pollution Research
Start-up of an anaerobic reactor is a relatively delicate process and depends on various factors such as wastewater composition, available inoculum, operating conditions and reactor configuration. Accordingly, systematized operational procedures are important, mainly during the start-up of an anaerobic reactor. In this paper, the start-up performance of an innovative multi-stage anaerobic reactorusing synthetic wastewater at various organic loading rates (OLRs) was investigated. In Phase 1 of the experimental study, the reactor was operated at hydraulic retention time (HRT) of 1 day with corresponding OLR of 1.07 kg COD.m-3.d-1. Thereafter, the reactor was operated at intermittent feeding (Phase 2), with HRT of 1.4 day and OLR of 0.82 to 2.45 kg COD.m-3.d-1. Results showed up to 71% COD reduction in the Phase 1 of the experimental study. However, in Phase 2, when the reactor was operated at intermittent feeding, the COD removal efficiency increased from 75 to 92%. It can be concluded that the multi-stage anaerobic reactor system performed better at intermittent feeding, indicating that the reactor required low loading rate and sufficient HRT for gradual acclimatization for reactor start-up. The reduction of the period necessary for the start-up and improved operational control are important factors to increase the efficiency the reactor system. Key words: Anaerobic reactor start-up, biomass, glucose wastewater, intermittent feeding, multi-stage anaerobic reactor.
11 February 2024 in Wood Material Science & Engineering