Thommas Flores

Mr. Thommas Flores

Universidade Federal da Paraíba - UFPB
orcid

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
19 May 2022 in Sensors
Verified
Journal Article
Open access
PDF file
PAPedro Henrique Meira de Andrade
Pedro Henrique Meira de Andrade
Ivanovitch SilvaIvanovitch Silva
Ivanovitch Silva
Marianne SilvaMarianne Silva
Marianne Silva
TFThommas Flores
Thommas Flores
Jordão SilvaJordão Silva
Jordão Silva
Daniel CostaDaniel Costa
Daniel Costa
Vehicles are the major source of air pollution in modern cities, emitting excessive levels of CO2 and other noxious gases. Exploiting the OBD-II interface available on most vehicles, the continuous emission of such pollutants can be indirectly measured over time, although accuracy has been an important design issue when performing this task due the nature of the retrieved data. In this scenario, soft-sensor approaches can be adopted to process engine combustion data such as fuel injection and mass air flow, processing them to estimate pollution and transmitting the results for further analyses. Therefore, this article proposes a soft-sensor solution based on an embedded system designed to retrieve data from vehicles through their OBD-II interface, processing different inputs to provide estimated values of CO2 emissions over time. According to the type of data provided by the vehicle, two different algorithms are defined, and each follows a comprehensive mathematical formulation. Moreover, an unsupervised TinyML approach is also derived to remove outliers data when processing the computed data stream, improving the accuracy of the soft sensor as a whole while not requiring any interaction with cloud-based servers to operate. Initial results for an embedded implementation on the Freematics ONE+ board have shown the proposal’s feasibility with an acquisition frequency equal to 1Hz and emission granularity measure of gCO2/km.

18 April 2022 in Sensors
Verified
Journal Article
Open access
PDF file
RLRobson Pacífico Guimarães Lima
Robson Pacífico Guimarães Lima
Juan Moises Mauricio VillanuevaJuan Moises Mauricio Villanueva
Juan Moises Mauricio Villanueva
HGHeber P. Gomes
Heber P. Gomes
TFThommas Flores
Thommas Flores
A water supply system is considered an essential service to the population as it is about providing an essential good for life. This system typically consists of several sensors, transducers, pumps, etc., and some of these elements have high costs and/or complex installation. The indirect measurement of a quantity can be used to obtain a desired variable, dispensing with the use of a specific sensor in the plant. Among the contributions of this technique is the design of the pressure controller using the adaptive control, as well as the use of an artificial neural network for the construction of nonlinear models using inherent system parameters such as pressure, engine rotation frequency and control valve angle, with the purpose of estimating the flow. Among the various contributions of the research, we can highlight the suppression in the acquisition of physical flow meters, the elimination of physical installation and others. The validation was carried out through tests in an experimental bench located in the Laboratory of Energy and Hydraulic Efficiency in Sanitation of the Federal University of Paraiba. The results of the soft sensor were compared with those of an electromagnetic flux sensor, obtaining a maximum error of 10%.

29 October 2023
Verified
Conference Paper
Closed access
JSJordão Da Silva
Jordão Da Silva
TFThommas Flores
Thommas Flores
SJSilvan Júnior
Silvan Júnior
Ivanovitch SilvaIvanovitch Silva
Ivanovitch Silva
Potholes pose a substantial threat in urban settings, leading to vehicular damage and safety risks. Therefore, their prompt identification is essential for effective road maintenance. In this study, we undertake a comparative evaluation of the YOLOv5, YOLOv8, and FOMO models for pothole detection using the Tiny Machine Learning (TinyML) approach. We use an openly available dataset comprising images labeled with bounding boxes, train these models, and gauge their precision in identifying potholes at various input sizes. Furthermore, we track the carbon footprint during the training phase of these networks using Code Carbon. Finally, as we methodically decrease the intricacy of the detection network, we evaluate the effects of this reduction on energy usage and detection efficacy. The outcomes suggest notable performance across all models, with the FOMO model standing out as the quickest and most energy-efficient model for pothole detection.

4 February 2022 in Sensors
Verified
Journal Article
Open access
PDF file
Rômulo Navega VieiraRômulo Navega Vieira
Rômulo Navega Vieira
Juan Moises Mauricio VillanuevaJuan Moises Mauricio Villanueva
Juan Moises Mauricio Villanueva
TFThommas Flores
Thommas Flores
Euler Cássio Tavares de MacêdoEuler Cássio Tavares de Macêdo
Euler Cássio Tavares de Macêdo
Nowadays, electric vehicles have gained great popularity due to their performance and efficiency. Investment in the development of this new technology is justified by increased consciousness of the environmental impacts caused by combustion vehicles such as greenhouse gas emissions, which have contributed to global warming as well as the depletion of non-oil renewable energy source. The lithium-ion battery is an appropriate choice for electric vehicles (EVs) due to its promising features of high voltage, high energy density, low self-discharge, and long life cycles. In this context, State of Charge (SoC) is one of the vital parameters of the battery management system (BMS). Nevertheless, because the discharge and charging of battery cells requires complicated chemical operations, it is therefore hard to determine the state of charge of the battery cell. This paper analyses the application of Artificial Neural Networks (ANNs) in the estimation of the SoC of lithium batteries using the NASA’s research center dataset. Normally, the learning of these networks is performed by some method based on a gradient, having the mean squared error as a cost function. This paper evaluates the substitution of this traditional function by a measure of similarity of the Information Theory, called the Maximum Correntropy Criterion (MCC). This measure of similarity allows statistical moments of a higher order to be considered during the training process. For this reason, it becomes more appropriate for non-Gaussian error distributions and makes training less sensitive to the presence of outliers. However, this can only be achieved by properly adjusting the width of the Gaussian kernel of the correntropy. The proper tuning of this parameter is done using adaptive strategies and genetic algorithms. The proposed identification model was developed using information for training and validation, using a dataset made available in a online repository maintained by NASA’s research center. The obtained results demonstrate that the use of correntropy, as a cost function in the error backpropagation algorithm, makes the identification procedure using ANN networks more robust when compared to the traditional Mean Squared Error.

7 January 2026 in Artificial Intelligence Review
Verified
Journal Article
Open access
PDF file
João Carlos N. BittencourtJoão Carlos N. Bittencourt
João Carlos N. Bittencourt
TFThommas Flores
Thommas Flores
Thiago JesusThiago Jesus
Thiago Jesus
Daniel CostaDaniel Costa
Daniel Costa
The rapid urbanization process has presented complex challenges that require innovative strategies to enhance urban living and promote sustainable growth. In this context, the concept of smart cities has quickly evolved, illustrating urban environments that utilize advanced technology to achieve greater efficiency, sustainability, and an improved quality of life for residents. The development of these smart environments relies on technologies like the Internet of Things (IoT), which collects extensive data through sensors, and Artificial Intelligence (AI), for advanced data processing and decision-making. For the latter, while traditional AI solutions have improved urban systems in multiple ways, emerging Generative Artificial Intelligence (GenAI) models signify a new era for smart cities, offering breakthroughs in urban design, simulation, and personalized, context-aware solutions. This article explores the applications, impacts, challenges, and promising future trends of GenAI within the context of smart cities, discussing generative urban intelligence perspectives for simulating alternative urban scenarios, co-designing infrastructure prototypes, and improving service delivery. It provides a pioneering perspective on an underexplored field that is expected to transform urban design, planning, and management.

18 January 2023 in Automation
Verified
Journal Article
Open access
PDF file
TFThommas Flores
Thommas Flores
Juan Moises Mauricio VillanuevaJuan Moises Mauricio Villanueva
Juan Moises Mauricio Villanueva
HGHeber P. Gomes
Heber P. Gomes
Automation and control systems are constantly evolving, using artificial intelligence techniques to implement new forms of control, such as fuzzy control, with advantages over classic control strategies, especially in non-linear systems. Water supply networks are complex systems with different operating configurations, uninterrupted operation requirements, equalization capacity and pressure control in the supply networks, and high reliability. In this sense, this work aims to develop a fuzzy pressure control system for a supply system with three possible operating configurations: a single motor pump, two motor pumps in series, or two motor pumps in parallel. For each configuration, an energy efficiency analysis was carried out according to the demand profile established in this case study. In order to validate the proposed methodology, an experimental water supply system was used, located in the Laboratory of Energy Efficiency and Hydraulics in Sanitation at the Federal University of Paraiba (LENHS/UFPB).