The work is devoted to the study of the climatic effects of black carbon (BC) transferred from forest fires to the Arctic zone. The HYSPLIT (The Hybrid Single-Particle Lagrangian Integrated Trajectory model) trajectory model was used to initially assess the potential for particle transport from fires. The results of the trajectory analysis of the 2019 fires showed that the probability of the transfer of particles to the Arctic ranges from 1% to 10%, and in some cases increases to 20%. Detailed studies of the possible influence of BC ejected as a result of fires became possible by using the climate model of the INMCM5 (Institute of Numerical Mathematics Climate Model). The results of the numerical experiments have shown that the maximum concentration of BC in the Arctic atmosphere is observed in July and August and is associated with emissions from fires. The deposition of BC in the Arctic increases by about 1.5–2 times in the same months, in comparison with simulation without forest fire emissions. This caused an average decrease in solar radiation forcing of 0.3–0.4 Wt/m² and an increase in atmospheric radiation heating of up to 5–6 Wt/m². To assess the radiation forcing from BC contaminated snow, we used the dependences of the change in the snow albedo on the snow depth, and the albedo of the underlying surface for a given amount of BC fallen on the snow. These dependences were constructed on the basis of the SNICAR (Snow, Ice, and Aerosol Radiative) model. According to our calculations, the direct radiative forcing from BC in the atmosphere with a clear sky is a maximum of 4–5 W/m² in July and August.

The lack of meteorological observations at high latitudes and the small size and relatively short lifetime of polar lows (PLs) constitute a problem in the simulation and prediction of these phenomena by numerical models. On the other hand, PLs, which are rapidly developing, can lead to such extreme weather events as stormy waves, strong winds, the icing of ships, and snowfalls with low visibility, which can influence communication along the Arctic seas. This article is devoted to studying the possibility of the numerical simulation and prediction of polar lows by different model configurations and resolutions. The results of the numerical experiments for the Norwegian and Barents seas with grid spacings of 6.5 and 2 km using the ICON-Ru configurations of the ICON (ICOsahedral Nonhydrostatic) model and with a grid spacing of 6.5 km using the COSMO-CLM (Climate Limited-area Modeling) configuration of the COSMO (COnsortium for Small-scale MOdelling) model are presented for the cold season of 2019–2020. All the used model configurations demonstrated the possibility of the realistic simulation of polar lows. The ICON model showed slightly more accurate results for the analyzed cases. The best results showed runs with lead times of less than a day.

Considered are the following possible approaches to get over the crisis: the rapid reduction of anthropogenic emissions of CO₂, the removal of CO₂ excess from the atmosphere, and the targeted change in the balance of coming solar radiation. Presented are the basic engineering methods of CO₂ removal which are able to ensure the negative emission of CO₂ at the level of a gigaton per year. The maximum possible potential is assessed, the scenario till 2300 is formulated, and the average lifetime of CO₂ in the sequestration reservoir is estimated for each method. Model computations demonstrated that even the whole set of negative emission methods cannot ensure the stabilization of global temperature at the permissible level under the most pessimistic scenarios of CO₂ concentration increase in the atmosphere. The conclusion is made that since the middle of the 21st century the humanity will have to use all three approaches to bar the hazardous exceeding of the average global temperature.

The current technology used at the Hydrometeorological Research Center of Russia for forecasting the meteorological indicator of pollution dispersion (MIPD

Polar mesocyclones are often the cause of sudden worsening of weather conditions, including strong winds, snowfall with low visibility, and storms. The short lifetime, rapid development, high movement speeds, and small sizes, combined with a lack of meteorological observations over the Arctic seas, create difficulties in forecasting associated weather phenomena. High-resolution numerical modeling can help address this issue. The emergence and development of polar lows (PLs) significantly depend on the properties of the underlying surface, which largely determine the dynamic properties of the atmosphere in the boundary layer. This article is dedicated to assessing the sensitivity of the configuration ICON-Ru of the model ICON with a 2.0 km grid spacing to changes in the sea ice boundary and sea surface temperature (SST) when forecasting the formation and development of PLs. The results showed that the presence of artificial ice in the model almost completely suppresses the development of PLs in cases where the vortex does not have a strong connection with the jet stream. Heating the SST to 278.15 K while simultaneously shifting the ice boundary northward leads to increased thermal instability, rising sensible and latent heat fluxes, and higher CAPE, which enhances PLs, with the degree of enhancement depending on the nature of the vortex formation itself.