The aim of the study was to determine the effect of the addition of black cumin (Nigella sativa L.) pressing waste (BCW) and black cumin seeds (BCS) on the properties of starch bread. The control bread was prepared from wheat starch (100%) with a gluten-free certificate, plantain husk (5%), and guar gum (2%). BCS and BCW were added between 0 and 10% of wheat starch. We determined the physicochemical properties, color, texture, and sensory properties of the prepared bread. Gas chromatography–mass spectrometry (GC–MS) analysis was performed to detect the phenolic compounds in the bread. The bread prepared with 6% BCS and 4% BCW had a significantly higher volume than the starch control bread did. Sensory analysis (taste) showed that BCS and BCW could be added up to 4% and 8%, respectively. The addition of BCS and BCW reduced the brightness of the crumb. A significant decrease in the L * index of the crumb was observed from 50.9 for the control bread to 34.1 and 34.0 for bread with 10% BCS and BCW, respectively. The addition of BCS and BCW decreased the hardness, elasticity, and chewiness of the starch bread crumb. Starch bread enriched with BCS and BCW was characterized by a higher content of 2-hydroxybenzoic acid, 2-hydroxyphenyl acetic acid, and 4-hydroxyphenyl acetic acid.

The aim of the present study was to determine the characteristics of oat cookies with the addition of apple (“A”: 5, 10%) and carrot pomace (“C”: 5, 10%). Modifying the recipe and fortifying the oat cookies with such byproducts decreased the hardness and increased the elasticity and chewiness. A colour change in the products containing fruit pomace was also observed. The use of carrot and apple residues resulted in a decrease in the value of the L* parameter, i.e., colour brightness. Moreover, for cookies containing carrot pomace, a significant increase in colour chromaticity towards red and yellow was observed. Fortified oatmeal cookies contained more polyphenols (0.67 mg/g–“CP”, control probe; 0.92 mg/g–“C10”) and fat (21.85%–“CP”; 22.55%–“A10”) but less protein (10.78%–“CP”; 10.25%–“C10”). A higher content of some minerals, i.e., P (0.334%–“CP”; 0.468%–“A10”), K (0.325%–“CP”; 0.387%–“C10”), and Ca (0.057%–“CP”; 0.073%–“C10”), was recorded in the cookies fortified with pomace. The obtained results indicate the significant impact of the addition of apple and carrot residues on the textural properties, colour parameters, and chemical composition of oat cookies. Pomace can be used to increase the content of antioxidants and microelements in this type of product.

The aim of the study was to evaluate the possibility of utilizing ultrasonic pasteurization as an alternative method to the standard pasteurization technique used for ice cream mixes. In addition, the possibility of replacing commercial stabilizers (guar gum (GG) and carboxymethylcellulose (CMC)) with arrowroot was assessed. The evaluation of the ice cream involved an analysis of its chemical composition and physical properties, including X-ray diffraction and microstructure analysis. The ice cream containing arrowroot and undergoing ultrasonic pasteurization exhibited significantly higher content of total solids (47.17%), protein (16.26 [g·(100 g)⁻¹]), and free reducing sugars while displaying a notably lower fat content (6.60 [g·(100·g)⁻¹]). The combination of arrowroot and ultrasonic pasteurization exerted a positive effect on reducing the apparent viscosity of the ice cream mixture (166.10 mPa·s). Consequently, it led to decreased hardness (19.97 N), increased overrun (87.02%), and extended melting time (37.48 min) in comparison to ice creams incorporating GG and CMC with traditional pasteurization. The study showed that arrowroot is a promising alternative to standard commercial stabilizers (CMC and GG) in ice cream production, while ultrasound pasteurization has the potential to replace traditional pasteurization methods.

This paper presents the results of an experiment based on using a Glide-arc type plasma reactor operating at atmospheric pressure for the quality of fresh pressed tomato juice, variety Bekas. The impact of after-glow plasma gas (air) on the physicochemical, microbiological properties and morphology of the product’s samples was investigated. Five groups of juices characterized by different exposure times (30, 60, 120, 300 and 600 s), as well as untreated juice (as control) were used. The juice quality was assessed on days 1, 3, 5, and 10 of refrigerated storage. Significant increases were observed when Cold Atmospheric Plasma (CAP)-treated tomato juice was tested against total soluble solids, pH, lycopene, and vitamin C in comparison to the control treatments. Moreover, changes in the tested physicochemical values during the storage of juice subjected to the action of cold plasma did not progress as quickly as in the case of the control juice. A significant decrease was observed in total plate count, yeast, and mold after 300–600 s CAP treatment. The findings of the current study suggested that CAP treatment is a promising technique that could provide improved quality and stability during the processing of tomato juice with better physicochemical properties and bioavailable nutrients.

There is currently a growing interest in oils characterised by specific medicinal, cosmetic, or dietary properties. For this reason, the seeds of two plants, milk thistle (Silybum marianum Gaertn) and borage (Borago officinalis L.), were studied by subjecting them to the process of cold pressing. The extracted oils were then examined in terms of their chemical composition and biological activity, and qualitatively analysed with the use of FTIR spectroscopy. The oils contained linoleic and octadecenoic acids in amounts of 47.84%, 35.31% (milk thistle oil) and 35.43%, 25.18% (borage oil). They were characterised by low water content, roughly 0.088% for thistle and 0.075% for borage, and simultaneously relatively high phosphorus content, reaching, respectively, 47.7 and 33.1 mg·kg⁻¹. The mean peroxide value was 4.22 for milk thistle and 2.83 mmolO₂·kg⁻¹ for borage, and the acid number was 5.17 and 3.9 mgKOH·g⁻¹, respectively. FTIR spectroscopy was used to conduct a qualitative analysis, which revealed slight discrepancies in intensity at 3005 cm⁻¹, which confirmed differences in the content of fatty acids and oil pigments between the oils. The obtained results provided information on the applicability of the studied seeds and oils obtained therefrom as basic components of pharmaceutical and cosmetic products with potential health benefits.