This study investigated the polymer film composite of polyvinyl alcohol (PVA), trichlorethylene (TCE) and cresol red (CR) dye irradiated with gamma (γ) rays for potential application as radiation dosimetry. The film was prepared via the solvent-casting method with varying concentrations of TCE. Film samples were exposed to radiation from a γ-rays radiation source of 60Cobalt isotope. Color changes before and after γ-rays irradiation were observed, and the optical properties of the polymer films were investigated by spectrophotometry. Results show that increasing the radiation dose physically changed the color of the polymer film, from purple (pH > 8.8) without radiation (0 kGy) to yellow (almost transparent) (2.8 < pH < 7.2) at the highest dose (12 kGy). The concentration of acid formed due to irradiation increased with the increase in irradiation doses and at higher TCE content. The critical doses of PVA-TCE composites decreased linearly with the increase of TCE composition, facilitating an easy calibration process. The dose response at 438 nm increased exponentially with increasing radiation dose, but showed an opposite trend at the 575 nm band. An increase in the TCA concentration indicated a decrease in the absorption edge and an increase in activation energy, but both decreased for all TCE concentrations at higher doses. The energy gap for the direct and the indirect transitions decreased with increasing TCE concentration and γ-rays radiation dose. The results of this study demonstrated the potential application of PVA-TCE-CR polymer film as γ-rays irradiation dosimetry in a useful dose range of 0–12 kGy.
A combination of carbon nanotubes (CNT) and graphene in the form of macroscopic hybrid buckypaper (HBP), exhibits a unique set of properties that can be exploited for many emerging applications. Here, we present a simple, inexpensive and scalable approach for the synthesis of highly conductive auxetic graphene/CNT HBP via wet-filtration-zipping and demonstrate the electrical, electrochemical and mechanical performance (tensile, mode I and mode III fracture) of synthesized HBP. An overall increase in electrical conductivity of 247% is observed for HBP (50 wt.% graphene and 50 wt.% CNT) as compared to BP (100 wt.% CNT) due to effective electronic percolation through the graphene and CNT. As a negative electrode for lithium-ion batteries, HBP shows 50% higher gravimetric specific capacity and 89% lower charge transfer resistance relative to BP. The graphene content in the HBP influences the mechanical performance providing an auxetic structure to HBP with large negative Poisson’s ratio. The facile green-chemistry approach reported here can be readily applied to any other 1D and 2D materials and solves key challenges associated with existing buckypaper manufacturing methods. The potential of the synthesis method to integrate with current cellulose paper manufacturing technology and its scalability demonstrate the novelty of the work for industrial scale production.
This study assesses the optical properties and conductivity of PVA–H3PO4 (polyvinyl alcohol–phosphoric acid) polymer film blend irradiated by gamma (γ) rays. The PVA–H3PO4 polymer film blend was prepared by the solvent-casting method at H3PO4 concentrations of 75 v% and 85 v%, and then irradiated up to 25 kGy using γ-rays from the Cobalt-60 isotope source. The optical absorption spectrum was measured using an ultraviolet–visible spectrophotometer over a wavelength range of 200 to 700 nm. It was found that the absorption peaks are in three regions, namely two peaks in the ultraviolet region (310 and 350 nm) and one peak in the visible region (550 nm). The presence of an absorption peak after being exposed to hυ energy indicates a transition of electrons from HOMO to LUMO within the polymer chain. The study of optical absorption shows that the energy band gap (energy gap) depends on the radiation dose and the concentration of H3PO4 in the polymer film blend. The optical absorption, absorption edge, and energy gap decrease with increasing H3PO4 concentration and radiation dose. The interaction between PVA and H3PO4 blend led to an increase in the conductivity of the resulting polymer blend film.
21 October 2024 in Results in Surfaces and Interfaces