This paper deals with different approaches to describing the relationship between the bending moment and curvature of a Euler—Bernoulli beam undergoing a large deformation, from a tutorial point of view. First, the concepts of the mathematical and physical curvature are presented in detail. Then, in the case of a cantilevered beam subjected to a single moment at its free end, the difference between the linear theory and the nonlinear theory based on both the mathematical curvature and the physical curvature is shown. It is emphasized that a careless use of the nonlinear mathematical curvature and moment relationship given in most standard textbooks may lead to erroneous results. Furthermore, a numerical example is given for the reader to make a quantitative assessment.
In this paper, a structural design and controller optimization process for a five-bar planar manipulator are studied using three different population-based optimization techniques: particle swarm optimization, genetic algorithm, and differential evolution. First, the desired kinematic properties of the manipulator, such as the position, velocity, and acceleration of the endpoint, are determined using inverse kinematics. Then, an optimization problem is created to minimize the shaking force and moments, and the desired kinematic quantities are implemented as constraints. All the link properties of the manipulator are defined as design variables, and the optimization results are obtained. The results show that it is possible to significantly reduce the shaking force and moment significantly thanks to the optimal design parameters. Finally, the controller is optimized to find the best PID gains considering the forward kinematics of the manipulator. It is observed that the shaking force and shaking moment can be reduced by 99% and 54%, respectively, which has a very positive effect on the accuracy of the trajectory tracking. Moreover, the performances of the optimization methods are compared by using the same number of iterations in the calculations, and thus, it can be seen that the GA method achieves the best results compared to the others. Therefore, the results of this study are of utmost importance for a manufacturer, who wants to design a five-bar planar manipulator and its controller.
In this paper, the equations of motion of a rotating beam encountered in various mechanical systems are given in the Euler-Newtoian form using four different dynamic modelling approaches. These models differ from each other in that they use different elastic displacements to define the state of deformed beam, i.e. the longitudinal and transversal deflections model, the axial and transversal deflections model, the axial, transversal deflections and slope angle model, and finally the transversal deflection with normal force model, which are abbreviatedly denoted by the UVM, the SVM, the SVφM, and the VNM. Following a brief discussion about geometric relationship among three linear elastic displacements,–that is, the longitudinal u-, the transversal ν-, and the axial s-displacements– geometric stiffening effect, and the choice of spatial functions consistent with boundary conditions to discretize equations of motion, simulation results found from these models are presented in graphics, and comparatively evaluated. It is concluded that the SVM and the SVφM is most reliable models provided that the comparison functions for axial displacement s are the eigenmodes of a fixed-free, longitudinally vibrating rod. The VNM appears to be a prudential model, because it always gives results above those obtained by the SVM.