Purifying biogas by removing contaminants and carbon dioxide (CO2) to produce biomethane enhances its energy content, making it suitable as fuel and for injection into natural gas grids. Bamboo-derived adsorbents Bamboo-500 (pyrolyzed at 500 °C), Bamboo-700 (pyrolyzed at 700 °C), and Bamboo-A-900 (activated with CO2 at 900 °C) were synthesized and characterized to evaluate their performance for CO2 and CH4 adsorption. Increasing pyrolysis temperature from 500 °C to 700 °C and further CO2 activation at 900 °C enhanced adsorption capacities of CO2 and CH4 due to improved surface area and micropore structure. In this study, the novel Approximate Adsorption Performance Indicator (AAPI) approach is introduced, offering an efficient method for evaluating adsorbent performance, particularly in biogas upgrading. AAPI results suggest Bamboo-500 is suitable for biogas upgrading at very low pressures (<0.12 MPa) with low regeneration energy and acceptable CO2 capacity (1.9 ± 0.2 mol kg−1). However, Bamboo-A-900 excelled at medium and high pressures by its highest CO2 adsorption capacity (8.0 ± 0.3 mol kg−1) promoted by the high surface area (1220 m2g−1) and calcium oxide presence. Finally, Bamboo-A-900 shows promise for enhancing CO2 adsorption and biogas upgrading. Bamboo-derived adsorbents offer a sustainable solution for biogas upgrading, supporting Sustainable Development Goals by promoting clean energy transitions.
29 May 2025 in International Journal of Thermophysics
This study is a continuation of a series of works concerning the acquisition of new experimental data related to binary mixtures of branched alkanes with CO2. A synthetic method was employed to measure phase transition pressures for the systems CO2 + 2,2-dimethylbutane and CO2 + 2-methylpentane with an adjustable-volume high-pressure cell. To our knowledge, these binary systems were investigated for the first time in this work. Bubble and dew point pressures were obtained by visual detection at constant composition with an expanded uncertainty ranging from (0.04 to 0.08) MPa. Mixtures were investigated at temperatures ranging from (293.15 to 363.15) K with pressures up to 11 MPa. The Peng-Robinson equation of state was used to correlate the experimental data. An accurate representation of the results has been obtained by using classical mixing rules with temperature-dependent binary interaction parameters regressed against experimental data. The predictive model PPR78 has also provided satisfactory results.
4 July 2025 in Chemical Engineering Journal Advances
The preliminary selection of adsorbents for the separation of a gas mixture based on pure gas adsorption remains a critical challenge; thus, an approximate adsorption performance indicator (AAPI) was proposed for the initial evaluation of the adsorbents to separate the biogas main constituents (carbon dioxide/methane (CO2/CH4)) by studying their pure gas adsorption. Three samples derived from cocoa pod husk (CPH), namely Cabosse-500 (pyrolyzed at 500 °C), Cabosse-700 (pyrolyzed at 700 °C), and Cabosse-A-700 (activated with CO2 at 700 °C), were synthesized, characterized, and evaluated for the pure gases adsorption. This study presents an AAPI evaluation, which takes into account adsorption capacity, approximate selectivity, and heat of adsorption. Adsorption isotherms indicate the ability of the CPH family to selectively capture CO2 over CH4, as they have a high approximate selectivity (>1) thanks to their physical properties. Changing the pyrolysis temperature, activation methods, and varying the pressure can significantly change the choice of the most effective adsorbent; Cabosse-A-700 showed better performance than the other two in the low and high pressure range owing to its presence of micropores and mesopores, which enhances the CO2 adsorption and therefore the AAPI.