An optical–chemical sensor based on two modified plastic optical fibers (POFs) and a molecularly imprinted polymer (MIP) is realized and tested for the detection of 2-furaldehyde (2-FAL). The 2-FAL measurement is a scientific topic of great interest in different application fields, such as human health and life status monitoring in power transformers. The proposed sensor is realized by using two POFs as segmented waveguides (SW) coupled through a micro-trench milled between the fibers and then filled with a specific MIP for the 2-FAL detection. The experimental results show that the developed intensity-based sensor system is highly selective and sensitive to 2-FAL detection in aqueous solutions, with a limit of detection of about 0.04 mg L−1. The proposed sensing approach is simple and low-cost, and it shows performance comparable to that of plasmonic MIP-based sensors present in the literature for 2-FAL detection.
In this study, a surface plasmon resonance (SPR) sensor based on modified plastic optical fibers (POFs) was combined with a specific molecularly imprinted polymer (MIP), used as a synthetic receptor, for glyphosate (GLY) determination in aqueous solutions. Since GLY is a non-selective herbicide associated with severe environmental and health problems, detecting glyphosate in environmental and biological samples remains challenging. The selective interaction between the MIP layer and GLY is monitored by exploiting the SPR phenomenon at the POF’s gold surface. Experimental results show that in about ten minutes and by dropping microliter volume samples, the presented optical–chemical sensor can quantify up to three orders of magnitude of GLY concentrations, from nanomolar to micromolar, due to a thin MIP layer over the SPR surface. The developed optical–chemical sensor presents a detection limit of about 1 nM and can be used for onsite GLY measurements. Moreover, the experimental analysis demonstrated the high selectivity of the proposed POF-based chemical sensor.
Optical–chemical sensors based on optical fibers can be made in reflection or transmission schemes. In the reflection scheme, the sensing area is typically present at the end of the fiber, and the light source and the detector are placed on the same side of the fiber. This approach can be exploited to achieve chemical probes useful in several application fields where remote sensing is required. In this work, to obtain an extrinsic optical fiber chemical sensor in a reflection scheme, two optical fibers are used to monitor a chemically sensitive region achieved by a C-shaped waveguide with a molecularly imprinted polymer (MIP) as a core between the optical fibers. The proposed micrometer-sized probe is developed and tested as a proof of concept via a MIP for 2-Furaldehyde (2-FAL) detection of interest in food and industrial applications. The experimental results of the proposed sensing approach showed several advantages, such as a nanomolar detection limit and an ultra-wide concentration detection range due to different kinds of MIP recognition sites in the optical path between the fibers.
This work presents an intrinsic optical fiber sensor based on plasmonic phenomena in modified plastic optical fibers (POFs). The sensing area is achieved by replacing the polymethyl methacrylate (PMMA) core with a molecularly imprinted polymer (MIP) containing gold nanorods (GNRs). Thus, in the sensing area, the MIP acts as both a selective recognition element and an optically sensitive guiding medium where plasmonic phenomena occur. This optical–chemical configuration has been developed as a proof-of-concept for the detection of furfural in aqueous solution. The proposed sensor achieves a limit of detection (LOD) of 27 pM, demonstrates high selectivity for the analyte of interest, and is applicable even in real-world scenarios, as demonstrated by experimental results (a commercially available infant milk). The proposed sensor presents a significant enhancement of the sensor response, of about six orders of magnitude, compared to a conventional configuration where the same (or a similar) mixture of MIP/GNRs is spun over the exposed PMMA of a D-shaped POF area for comparison. Notably, even if this study has been carried out via a proof-of-concept in furfural detection, this substantial improvement is achieved while preserving a simple, portable, and cost-effective optical setup, highlighting the potential of this sensing strategy for the development of highly selective sensors by changing the MIP template.