Daryl Key

Mr. Daryl Key


Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
3 August 2022 in Crystals
Verified
Journal Article
Open access
PDF file
THTadao Hashimoto
Tadao Hashimoto
ELEdward R. Letts
Edward R. Letts
DKDaryl Key
Daryl Key
This paper reviews the near-equilibrium ammonothermal (NEAT) growth of bulk gallium nitride (GaN) crystals and reports the evaluation of 2″ GaN substrates and 100 mmbulk GaN crystal grown in our pilot production reactor. Recent progress in oxygen reduction enabled growing NEAT GaN substrates with lower residual oxygen, coloration, and optical absorption. The oxygen concentration was approximately 2 × 1018 cm−2, and the optical absorption coefficient was 1.3 cm−1 at 450 nm. Maps of full-width half maximum (FWHM) of X-ray diffraction rocking curveswere generated for grown crystals and finished wafers. The X-ray rocking curve maps confirmed high-quality and uniform microstructure across the entire surface of the bulk crystals and substrates. The average FWHM of the 50 best bulk crystals from the recent batch was 28 ± 4 arcsec for the 002 diffraction and 34 ± 5 arcsec for the 201 diffraction, with an average radius of curvature of 20 m. X-ray topography measured on both sides of the bulk crystals implied that the density of dislocations wasreduced by one order of magnitude during the NEAT growth. A typical NEAT GaN substrate shows dislocation density of about 2 × 105 cm−2.

2 October 2023 in Applied Physics Letters
Verified
Journal Article
Closed access
PDF file
YXYibo Xu
Yibo Xu
VVVijay Gopal Thirupakuzi Vangipuram
Vijay Gopal Thirupakuzi Vangipuram
VTVishank Talesara
Vishank Talesara
JCJunao Cheng
Junao Cheng
YZYuxuan Zhang
Yuxuan Zhang
WLWu Lu
Wu Lu
Devices based on gallium nitride (GaN) have great potential for high power switching applications due to the high breakdown field and high electron mobility. In this work, we present a vertical GaN-on-GaN PN power diode using high dielectric constant material, BaTiO3, for electrical field management and high breakdown voltages, in together with an optimized guard-ring and field plate design. Numerical simulation shows that with high-k dielectrics implemented, the peak electrical field at the PN interface is mitigated from 3.5 to 3.1 MV/cm under a reverse bias of −9.05 kV. The device design with BaTiO3 shows a breakdown voltage of 9.65 kV or about 600 V improvement. The fabricated diodes with a 57 μm thick drift layer demonstrate a breakdown voltage of 7.86 kV on a bulk GaN substrate. The device has an on-resistance of 2.8 mΩ cm2 and a Baliga figure of merit of 22 GW/cm2.

14 June 2019 in Materials
Verified
Journal Article
Open access
PDF file
DKDaryl Key
Daryl Key
ELEdward Letts
Edward Letts
CTChuan-Wei Tsou
Chuan-Wei Tsou
MJMi-Hee Ji
Mi-Hee Ji
MBMarzieh Bakhtiary-Noodeh
Marzieh Bakhtiary-Noodeh
THTadao Hashimoto
Tadao Hashimoto
Free-standing gallium nitride (GaN) substrates are in high demand for power devices, laser diodes, and high-power light emitting diodes (LEDs). SixPoint Materials Inc. has begun producing 2” GaN substrates through our proprietary Near Equilibrium AmmonoThermal (NEAT) growth technology. In a single 90 day growth, eleven c-plane GaN boules were grown from free-standing hydride vapor phase epitaxy (HVPE) GaN substrates. The boules had an average X-ray rocking curve full width at half maximum (FWHM) of 33 ± 4 in the 002 reflection and 44 ± 6 in the 201 reflection using 0.3 mm divergence slits. The boules had an average radius of curvature of 10.16 ± 3.63 m. The quality of the boules was highly correlated to the quality of the seeds. A PIN diode grown at Georgia Tech on a NEAT GaN substrate had an ideality factor of 2.08, a high breakdown voltage of 1430 V, and Baliga’s Figure of Merit of >9.2 GW/cm2. These initial results demonstrate the suitability of using NEAT GaN substrates for high-quality MOCVD growth and fabrication of high-power vertical GaN switching devices.

1 March 2022 in Japanese Journal of Applied Physics
Verified
Journal Article
Closed access
DKDaryl Key
Daryl Key
BJBenjamin Jordan
Benjamin Jordan
ELEd Letts
Ed Letts
THTadao Hashimoto
Tadao Hashimoto
X-ray topography measurements on a 100 mm diameter GaN boule grown by the Near Equilibrium AmmonoThermal method revealed an improvement in dislocation density from >1 × 10 6 cm −2 to between 2 × 10 5 and 5 × 10 5 cm −2 , an improvement greater than two to five times from seed to growth. This data builds on previous X-ray diffraction and defect selective etching to quantify the reduction in defect density that is closely associated with increasing growth thickness. This result indicates that there is a pathway to further dislocation reduction by increasing growth thickness for GaN crystals including those of 100 mm or larger diameter. Further reduction of the dislocation density of large-area substrates will lead to GaN power devices with reduced leakage current under reverse bias and better device performance.

28 May 2024 in Journal of Applied Physics
Verified
Journal Article
Open access
PDF file
ZXZhiyu Xu
Zhiyu Xu
MDMatthias A. Daeumer
Matthias A. Daeumer
MCMinkyu Cho
Minkyu Cho
JYJae-Hyuck Yoo
Jae-Hyuck Yoo
TDTheeradetch Detchprohm
Theeradetch Detchprohm
SSShyh-Chiang Shen
Shyh-Chiang Shen
This work reports analysis of the reverse-bias breakdown characteristics of homojunction gallium nitride (GaN) p–i–n (PIN) rectifiers fabricated on bulk GaN substrates. Sub-bandgap photoluminescence mapping at room temperature as a contactless, non-destructive wafer inspection method was performed to analyze the impact of material properties on grown GaN PIN diodes and to study the correlation between defect types and breakdown characteristics of vertical GaN PIN rectifiers. Under the sub-bandgap excitation, yellow luminescence is dominant. The premature breakdown characteristics of the fabricated kV-class vertical GaN PIN rectifiers with nitrogen-implanted floating guard rings are found to be associated with material defects and deep level complexes. Photoluminescence mapping has demonstrated its effectiveness in quantitative analysis of dislocations and other types of defects.

13 April 2026 in APL Electronic Devices
Verified
Journal Article
Open access
YXYibo Xu
Yibo Xu
VVVijay Gopal Thirupakuzi Vangipuram
Vijay Gopal Thirupakuzi Vangipuram
THTadao Hashimoto
Tadao Hashimoto
ELEdward Letts
Edward Letts
DKDaryl Key
Daryl Key
WLWu Lu
Wu Lu
GaN-based power devices have great potential for medium-to-high voltage applications. In this work, we present the device design of a vertical GaN-on-GaN PN power diode using a double field plate structure and guard-rings for electrical field management to achieve a 10 kV breakdown voltage. Simulations show that this device design with a 75 μm thick drift layer and a doping density of 1 × 1015 cm−3 has a breakdown voltage of 10.5 kV and ∼90.5% electrical field management efficiency. Experimentally, the fabricated diode with a ∼74 μm thick drift layer and Nd–Na concentration of 1 × 1015 cm−3 demonstrates a breakdown voltage of 10.3 kV on a bulk GaN substrate. The device has an on-resistance of 8 mΩ cm2 and a Baliga figure of merit of 13.3 GW/cm2. Compared to the theoretical breakdown voltage of this device design, the fabricated device has an overall breakdown efficiency of 89%.