Battery models have gained great importance in recent years, thanks to the increasingly massive penetration of electric vehicles in the transport market. Accurate battery models are needed to evaluate battery performances and design an efficient battery management system. Different modeling approaches are available in literature, each one with its own advantages and disadvantages. In general, more complex models give accurate results, at the cost of higher computational efforts and time-consuming and costly laboratory testing for parametrization. For these reasons, for early stage evaluation and design of battery management systems, models with simple parameter identification procedures are the most appropriate and feasible solutions. In this article, three different battery modeling approaches are considered, and their parameters’ identification are described. Two of the chosen models require no laboratory tests for parametrization, and most of the information are derived from the manufacturer’s datasheet, while the last battery model requires some laboratory assessments. The models are then validated at steady state, comparing the simulation results with the datasheet discharge curves, and in transient operation, comparing the simulation results with experimental results. The three modeling and parametrization approaches are systematically applied to the LG 18650HG2 lithium-ion cell, and results are presented, compared and discussed.

All types of fluctuations of the rms voltage in power systems may be assessed by using a "flickermeter" which complies with the specifications given in IEC-EN 60868. In this paper, a digital flickermeter is presented based on the implementation in the frequency domain of the weighting filter block of the eye-brain simulation chain. The virtual instrument, implemented with an acquisition board inserted into a PC and with a software developed with the LabView tools, samples the voltage and furnishes the instantaneous flicker level and other severity coefficients. Results of simulated and actual data are reported to validate the performance of the developed flickermeter.

This paper shows the technical and economical evaluation of the application of a reconfiguration system for photovoltaic (PV) plants, considering the incentives system in some European Union countries. The reconfiguration system is an alternative to the distributed maximum power point tracking technique which used to increase the power production in the PV plants under the mismatch phenomenon. The reconfiguration techniques employ a microprocessor-based or field-programmable gate array-based system that modifies the layout of the PV plant through the change of the connections among modules. After having presented the main features working of the PV reconfiguration system allowing the improvement of the efficiency of the same plant and the relevant installation, the main strength and weakness points of the investment are evidenced in relation to different incentives policies in some country of UE.

In this paper a model to predict the harvest of the energy contained in rainfall by means of piezoelectric transducers is presented. Different studies agree on the level of suitable generated voltage on the electrodes of a piezoelectric transducer subjected to rainfall, but a complete characterization on the supplied power is still missing. This work, in order to limit optimistic forecasts, compares the behavior of the transducers subjected to real and artificial rainfall, a condition that has shown promising behavior in laboratory.

This paper presents the development of a high-accuracy sampling wattmeter, which can be employed with both sinusoidal and distorted input signals. The proposed personal computer (PC)-based system is a simple, portable, and low-cost solution because it is based on two commercial data acquisition boards connected to a common PC. Owing to this solution, the voltage is sensed directly, avoiding expensive voltage dividers, while the current is sensed by means of a noninductive current shunt. Commercial software is also used for data processing and implementation of the virtual instrument. The setup of the PC-based wattmeter is described, with a detailed description of the correction strategy of systematic contributions to the measurement uncertainty of analog-to-digital converter conversion. An experimental evaluation of its metrological performances is made by means of several experimental tests, with both sinusoidal and distorted voltages and currents, which were carried out with an electric power standard and a high-performance multifunction calibrator.