Quantum dot (QD) labeling combined with fluorescence lifetime imaging microscopy is proposed as a powerful transduction technique for the detection of DNA hybridization events. Fluorescence lifetime analysis of DNA microarray spots of hybridized QD labeled target indicated a characteristic lifetime value of 18.8 ns, compared to 13.3 ns obtained for spots of free QD solution, revealing that QD labels are sensitive to the spot microenvironment. Additionally, time gated detection was shown to improve the microarray image contrast ratio by 1.8, achieving femtomolar target sensitivity. Finally, lifetime multiplexing based on Qdot525 and Alexa430 was demonstrated using a single excitation-detection readout channel.
The development and application of magnetic technologies employing microfabricated magnetic structures for the production of switching components has generated enormous interest in the scientific and industrial communities over the last decade. Magnetic actuation offers many benefits when compared to other schemes for microelectromechanical systems (MEMS), including the generation of forces that have higher magnitude and longer range. Magnetic actuation can be achieved using different excitation sources, which create challenges related to the integration with other technologies, such as CMOS (Complementary Metal Oxide Semiconductor), and the requirement to reduce power consumption. Novel designs and technologies are therefore sought to enable the use of magnetic switching architectures in integrated MEMS devices, without incurring excessive energy consumption. This article reviews the status of magnetic MEMS technology and presents devices recently developed by various research groups, with key focuses on integrability and effective power management, in addition to the ability to integrate the technology with other microelectronic fabrication processes.
20 February 2015 in Journal of Microelectromechanical Systems
Microfabricated square electrodes with finely controlled highly reproducible dimensions have been developed for electrochemical analysis of high-temperature molten salt (MS). These microelectrodes have been fabricated using photolithographic techniques on silicon wafers and have been designed for operation in lithium chloride/potassium chloride eutectic salt at and ~500 °C. The electrodes are constructed from a series of patterned layers, and their development has involved a systematic study and optimization of a number of different material combinations. This has resulted in a process for making electrodes that represents a step change in capability, delivering the first robust microelectrode device capable of quantitative electroanalysis in a MS system at 500 °C.
27 August 2007 in IEEE Transactions on Device and Materials Reliability
This paper reports the first direct experimental measurement of electromigration-induced stress in aluminum interconnects, using a series of microrotating stress sensors. The build-up of stress gradients in interconnect metallization, which is concomitant with backstress, has been previously investigated theoretically, but experimental verification using optical or X-ray techniques has proven more difficult. These initial results show a compressive-stress gradient along the line of stress sensors, consistent with that predicted by conventional mass-transport theory. Additionally, these measurements are in qualitative agreement with the mathematical model proposed by Korhonen et al. (1993), with a reduced-stress and increased-diffusion coefficient. These differences are discussed, and the causes postulated. The limited resolution of previous techniques restricts their ability to obtain a detailed characterization, whereas, in principle, this new technique can be scaled to the end of the International Technology Roadmap for Semiconductors. These preliminary findings suggest that the presented technique will provide a valuable tool for the investigation of back-end-of-line interconnect stress in the future.
This article details and compares the technology options for post-processing foundry produced CMOS at chip-scale to enable More than Moore functionality. In many cases there are attractions in using chip-based processing through the Multi-Project Wafer route that is frequently employed in research, early-stage development and low-volume production. This article identifies that spray-based photoresist deposition combined with optical maskless lithography demonstrates sufficient performance combined with low cost and operational convenience to offer an attractive alternative to conventional optical lithography, where spin-coated photoresist is exposed through a patterned photomask. [2020-0249]