The oxygen starvation phenomenon is a dangerous operating condition that reduces the lifetime of PEM fuel cells. The detection and prevention of this undesired phenomenon require estimation of the oxygen excess ratio λO2. The mathematical complexities of the reported methods for obtaining λO2 complicate its real-time calculation and require high-performance computational devices, which significantly increase the costs of the system. In this paper, a mutual information approach is used in obtaining a simplified mathematical model for the calculation of λO2. The usage of such a simplified model requires much less computational power for real-time monitoring of the variable λO2, while it provides comparable results to those obtained by using the complex model. Therefore, it represents a cost-effective solution, suitable for usage within applications that require high sampling frequencies, like emulators, converter and air compressor control loops, simulations, etc. In order to validate the accuracy of this simplified λO2 calculation model, a real-time monitoring system was built and experimentally tested using both the simplified and complex models. The matching experimental results validate the proposed simplification and justify the use of this simplified model within real-time monitoring applications.
In this document features taken from Empirical Mode Decomposition (EMD) are selected by mutual information for the discrimination between letal and Seizure-Free EEG single-channel signals. Some features are based on the instantaneous or average frequency and amplitude of each EMD component. Also, skewness, kurtosis and Shannon's entropy are taken as features from the energy obtained using the Teager Energy Operator (TEO). TEO is calculated over each EMD component. Then a subset of relevant and non-redundant features is selected by normalized mutual information. Finally these selected features are used to train a linear Bayes classifier, and a 5-fold cross validation is performed for different clinical cases. We used a publicly available database to compare each feature extraction approach. Accuracies around 98% are reached by the implemented methodology.
This paper presents a general overview of the main characteristics of the wind power systems, also considerations about the simulation models andthe most used Maximum Power Point Tracker (MPPT) techniques are made. Some simulation results are shown and conclusions about the workare given.
25 July 2025 in IEEE Open Journal of the Industrial Electronics Society
Conventional model predictive control (MPC) of power converters has been widely found in many power electronics and motor drive applications. The performance of MPC strongly depends on the precision of the converter’s physical parameters, and a mismatch of them produces a control degradation, which leads to MPC suboptimal operation. Ensuring a precise estimation of the converter’s parameters is difficult because they continuously change during the operation process due to their operating point and aging. Recently, model-free predictive control (MF-PC) has been used in motor drives and power electronics converters, especially inverters and rectifiers, to deal with the predictive control method’s dependency model. However, MF-PC proposed for dc–dc converters is an open innovation scientific field. This article proposes an MF-PC designed for second-order dc–dc converters, such as the boost, buck, buck–boost, and noninverting buck–boost converters. The presented approach uses a Kalman filter to estimate the positive and negative inductor current slopes with high accuracy and a low computational cost. The experimental results show that the proposed method is robust against parameter and model changes compared to conventional model-based solutions.
This dataset presents the performance characteristics of photovoltaic (PV) panels under various fault conditions, including discoloration, cracks, and partial shading. The panels, SP090P Solar Plus Energy and HYBRYTEC-M5-30/12, were subjected to testing under three distinct scenarios: dirty surfaces, clean surfaces, and partial shading. Electrical parameters such as short-circuit current, open-circuit voltage, and output power, were measured, along with thermographic images to assess thermal performance under the specified conditions. Data was acquired using an electronic load system, oscilloscope, and thermographic camera, with testing conducted in outdoor environmental conditions. The results highlight the significant impact of faults and shading on the performance of PV panels, with notable reductions in power production. This dataset provides valuable insights into the real-world performance of PV systems and can serve as a reference for researchers focused on fault detection, optimization of maintenance strategies, and enhancing the overall efficiency of solar energy systems.