Functional verification schemes at a level different from component-level testing are emerging as a cost-effective tool for those space systems for which the risk associated with a lower level of assurance can be accepted. Despite the promising potential, system-level radiation testing can be applied to the functional verification of systems under restricted intrinsic boundaries. Most of them are related to the use of hadrons as opposed to heavy ions. Hadrons are preferred for the irradiation of any bulky system, in general, because of their deeper penetration capabilities. General guidelines about the test preparation and procedure for a high-level radiation test are provided to allow understanding which information can be extracted from these kinds of functional verification schemes in order to compare them with the reliability and availability requirements. The use of a general scaling factor for the observed high-level cross sections allows converting test cross sections into orbit rates.
26 March 2020 in IEEE Transactions on Nuclear Science
Combined effects of electrical stress and neutron irradiation of the last generation of commercial discrete silicon carbide power MOSFETs are studied. The Single Event Burnout (SEB) sensitivity during neutron irradiation is analyzed for unstressed and electrically stressed devices. For surviving devices, a comprehensive study of the breakdown voltage degradation is performed by coupling electrical stress and irradiation effects. In addition, mutual influences between electrical stress and radiative constraints are investigated through TCAD modeling.
5 May 2021 in IEEE Transactions on Nuclear Science
The mechanisms responsible for neutron-induced single-event burnout (SEB) in commercial silicon carbide power MOSFETs under atmospheric-like neutron spectrum were investigated and analyzed. The combined effect of applied reverse gate voltage and drain voltage was evaluated. First, local analysis of the packaged device at the wafer level is performed to reveal the failure mechanism inside the semiconductor lattice. Second, based on gate stress testing of surviving devices and looking at the influence of reverse gate bias during irradiation, an enhanced failure sensitivity especially for drain voltage values close to the safe operating area was demonstrated. In addition to support this assumption, TCAD simulations with damage sites were performed in order to address physical mechanisms related to gate leakage degradation and SEB.
19 May 2021 in IEEE Transactions on Nuclear Science
We present backside laser testing of gallium nitride (GaN) power devices on Si substrate using optical parameters compatible with three-photon absorption in GaN and single-photon absorption in the substrate. The laser/device interaction is described. Two different kinds of transients are observed at the gate electrode and analyzed. The technique allows identifying the sensitive regions of the devices and generating destructive events.
Electronic system reliability over soft errors is very critical as the transistor size shrinks. Many recent works have defined the device error rate under radiation for SRAMs in hold mode (static) and during operation (dynamic). This paper evaluates the impact of running test algorithms on SRAMs exposed to neutron radiation in order to define their stressing factor. The results that we show are based on experiments performed at the TSL facility in Uppsala, Sweden using a Quasi-Monoenergetic neutron beam. The evaluation of the test algorithms is based on the calculated device SEU cross section.