16 May 2023 in IEEE Transactions on Microwave Theory and Techniques
A first approach toward the integration of heterogeneous electronic circuit technologies and fully 3-D printed ceramic microwave devices is discussed in this work. Additive manufacturing (AM) capabilities are explored for the development of multifunction surface-mount compact components used in different RF front-ends’ scenarios. Monolithic ceramic bandpass filters (BPFs) are designed to operate in the $X$ -Band and to assess the typical limitations of ceramic stereolithography (SLA) processes. A post-fabrication tuning method based on a laser engraving strategy is presented to overcome the manufacturing constraints and carry out the filters’ correction. 2.5-D and 3-D printed four-pole filters were fabricated and tuned using the proposed methodology.
16 April 2018 in International Journal of Microwave and Wireless Technologies
This paper illustrates the different possibilities given by additive manufacturing technologies for the creation of passive microwave hardware. The paper more specifically highlights a prototyping scheme where the 3D-printed plastic parts can be used as initial proofs of concept before considering more advanced 3D-printed parts (metal parts, for instance). First, a characterization campaign has been made on common plastics used by a 3D printer using the fused deposition modeling and material jetting (Polyjet©) technologies. The impact of the manufacturing strategy (high-speed or high-accuracy) on the part roughness, as well as on the dielectric material permittivity and loss tangent, has been specifically studied at 10 and 16 GHz. Based on a specifically optimized and deeply explained characterization method, the conductivity of a coating based on silver paint has also been characterized on such plastic parts at 10 and 40 GHz. These plastic materials and coating have been used for the creation of quasi-elliptic and tuning-free bandpass filters centered at 6 and 12 GHz and compared with a similar filter made of stainless steel by selective laser melting. Finally, a compact rectangular TE 10 to circular TE 01 mode converter also undergoes one prototyping step out of plastic before moving to an advanced part made out of stainless steel. This mode converter, which is made in a single part, is designed to operate from 28 to 36 GHz as a tuning-free final demonstrator.
1 January 2026 in IEEE Microwave and Wireless Technology Letters
12 September 2025 in IEEE Microwave and Wireless Technology Letters
In this letter, a novel design method for 3-D microstrip filters is proposed. The method is valid for any all-pole transfer function and employs an inverse scattering synthesis technique to generate a smooth characteristic impedance profile that is implemented by smoothly varying the substrate height and strip width. In this way, strongly enhanced characteristic impedance excursions can be implemented, allowing us to synthesize filters with very wide rejection bands and very compact physical dimensions. As an example of application, a Ku-band low-pass filter (LPF) with cut-off frequency of 11.8 GHz and rejection band up to 36 GHz is designed, featuring a length of 10.66 mm. The filter is fabricated through additive manufacturing (AM) and the measurements obtained confirm its excellent performance.