16 October 2023 in IEEE Transactions on Power Electronics
In order to suppress the crosstalk in GaN based bridge configuration, this paper proposes a novel high frequency three-level gate driver (HFTGD), and the crosstalk suppression with switching frequency up to 5 MHz can be achieved. The capacitor-diode (C-D) circuit generates a negative voltage to prevent the false turn-on of the device under the impact of positive crosstalk. PWM generator work together with comparator circuit to rapidly clamps the negative voltage to zero level, thereby suppressing the negative crosstalk. In particular, HFTGD utilizes only two passive components to produce the negative voltage, and also has the advantages of good high frequency stability and adjustable negative voltage depth. The control signal of the zero-level clamp circuit is digitally implemented, resulting in a shorter clamp time and minimal impact on the switching speed of the GaN HEMT. Additionally, only a single power supply and a single control signal are required for HFTGD, which reduces the cost and control complexity. The effectiveness of HFTGD for positive and negative crosstalk suppression is demonstrated in a double-pulse test based on GS66504B
13 June 2025 in IEEE Transactions on Electron Devices
In this work, the degradation behavior of electrical characteristics of p-gallium nitride (GaN) gate HEMTs under high-power microwave (HPM) irradiation has been studied. The trap analysis of p-GaN gate HEMTs before and after HPM irradiation based on the 1/f noise method was carried out. The experimental results show that the threshold voltage of the p-GaN gate HEMTs under HPM irradiation is obviously lower than that of the fresh device and the subthreshold swing is larger than that of the fresh device. The maximum variation of gate leakage current increases by an order of magnitude. As the HPM power and the irradiation time increase, the degradation phenomenon of the p-GaN gate HEMT device becomes more severe. The 1/f noise results show that the input-referred flat-band spectral noise density in the p-GaN gate HEMTs had doubled under HPM irradiation. This indicates that the trap density in the p-GaN gate HEMTs has also doubled under HPM irradiation, which would lead to an increase in the subthreshold swing and gate leakage current of the device. Further study shows that HPM couples high-frequency potential differences between the pins of the device (the same frequency as HPM). The degradation of the device may be due to this high-frequency ac gate stress. The experimental results may be useful in the application of p-GaN gate HEMTs in complex electromagnetic environments.
9 March 2025 in Surfaces and Interfaces
29 August 2025 in IEEE Journal of Solid-State Circuits
This article presents a fractional output divider (FOD) incorporating a split-digital-to-time converter (DTC) architecture with fully digital background calibration for both gain errors and integral nonlinearity (INL) in DTC. The calibration scheme employs a mutual-reference mechanism between dual DTCs, where specifically configured DTC digital control words combined with redundancy and uncorrelated operations enable the bang–bang phase detector (BBPD) to extract both gain errors and INL from dual DTC phase differences. This allows the sign least-mean-square (sign-LMS) algorithm to iteratively update the gain calibration factor and INL error codes in the background. Fabricated in 28-nm CMOS technology, the prototype achieves a compact core area of 0.024 mm2 using standard digital cells (except varactors in the DTCs), operating at 0.9-V supply voltage with 3.36-mW power consumption. Measurement results demonstrate a root mean square (rms) jitter of 191 fs and spurious power of −81 dBc in measurements performed at 123.46 MHz with a division ratio of 20.25.
12 December 2024 in IEEE Electron Device Letters
This work investigated the impact of in-situ N 2 or H 2 /N 2 plasma pretreatment on the interface and border trap states between plasma-enhanced atomic layer deposition (PEALD) AlN and GaN in normally-off Si3N4/AlN/GaN MIS-HEMTs. The interface trap density with different time constants and the trap density at different energy levels of the interface traps are characterized by high frequency capacitance-voltage (HFCV) test and conductance method, respectively. The energy level & spatial distribution of the border traps and the border trap density are characterized by quasi-static capacitance C-V (QSCV) test and 1/ f noise method, respectively. It is found that in-situ H 2 /N 2 plasma pretreatment more effectively reduces the overall trap density compared to in-situ N 2 plasma pretreatment. Moreover, both plasma pretreatment process has a greater suppression effect on the border traps than on the interface traps compared to no plasma pretreatment. And it is more effective at suppressing the shallow interface traps than the deep ones.